Question about 1993 Jeep Grand Cherokee

2 Answers

The transmission is a 5 speed and its 2 wheel dr 93 Jeep Cherokee Sport.Where is the slave cylinder in the transmission located?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Find the clutch master cylinder follow the line down to the trans, it ends at the slave cylinder

Posted on Oct 16, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

There are two versions...the easiest to work on is located on the drivers side of the bellhousing. The other version is inside the bellhousing and is part of the throwout bearing (there will be a hose connection going into the bellhousing and a bleed valve protruding from the side of the bell housing on those) This version is used on later models but I have seen it used when engine/trans swaps have been previously made. Clutch master is on the firewall on the left side of the brake master cyl.

Posted on Oct 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No hydraulic clutch engagement in 1996 Jeep Cherokee Sport 5 speed


pump clutch watch fuild in master, it should go down and up with each pump and release. the master can be by passing. if the system has been drained you may have a air bubble in master. to remove air use a nose suckion ball, put in the bottom of master. be sure to suck it in the up and down spots

Feb 07, 2018 | Cars & Trucks

2 Answers

How do i install a engine speed sensor on my 1998 jeep grand cherokee loredo 4.0


Ther are more than one type of speed sensor for jeeps....I am chrysler jeep tech...there are 2 speed sensors on the trans and also speed sensors at the wheels (IF IT HAS ABS)...Normally the engine speed is done by an IAC Motor...If you are meaning idle...Can you send more information....
Also you may have a vacum leak..........You have an Input speed sensor and an output speed sensor ....Do you know exactly which it is ....Both are at transmission /If 4 wheel drive see transfer case also.I have the manual at my fingertips and will be glad to assist you with any problems............................I can help................metalpoet

Mar 03, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Location speed sensor cherokee 2006


If it is a four wheel drive it will be on the transfer case,
If two wheel drive it will be on transmission,it still looks like where a speedometer hookup,but it will have a sensor with three wires now

Jan 11, 2010 | 2006 Jeep Grand Cherokee

1 Answer

Oil leak from rear main seal 92 jeep cheeroke


remove transmission, remove flywheel, pry old seal out with seal remove or a screwdriver careful not to damage the block or crank. Clean surface with carberater cleaner or brake cleaner. Tap ne seal in with flat end of ball ping hammer. Put transmission back in.

Jan 05, 2010 | 1992 Jeep Cherokee Sport

1 Answer

LOCATION OF THE HYDROLIC CLUTCH CYLINDER ON A 93 AUDI 100S. THANKS


If you mean the clutch slave cylinder, it is under the dash attached directly to the pedal cluster.. the slave cylinder is located on top of the transmission, accessed from underneath the left front area behind the wheel...

Aug 26, 2009 | 1993 Audi 100

1 Answer

1993 Jeep Grand Cherokee Laredo wont drive when put into gear


No, not with out a lot of work. Electronics are most likely different on the 2 also.

Mar 11, 2009 | 1993 Jeep Grand Cherokee

1 Answer

1988 jeep cherokee 5 speed slips out of reverse


Sounds light u may have nock the shifter cable out of adjustment

Jan 19, 2009 | Jeep Cherokee Cars & Trucks

1 Answer

Where is slave cylinder on 1992 Jeep Cherokee?


Inside the Bell Housing, Behind the clutch.

Jan 15, 2009 | 1995 Jeep Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...