How do iturn the service light of on a sabb 93 2006

Don't really know about the Sabb's. But if you don't have a rest in the fuse panel. Then turn the ignition on, press the fuel pedal three times within five seconds. The light should flash, when it stops, turn the ignition off. this should reset it.

how is your air filter , believe it or not a dirty air filter will make your car run like crap , no power

was it tuned up too

Convertable not so fun when the top doesnt operate? Haha.
there is such a thing as a trunk lid sensor. Although I dont know
where its located, its a good place to start.

The valve regulating the water flow to the heat exchanger could be broken. It needs to be replace.

a sabb has the same problem and the common problem was the ABS module that controls all your warning lights and your climent controls.

P0131 - O2 Sensor Circuit Low Voltage Bank 1 Sensor 1 (sensor is before the catalytic converter)

Possible causes- Front Heated Oxygen Sensor Bank 1 harness is open or shorted
- Front Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Front Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
P0132 - O2 Sensor Circuit High Voltage Bank 1 Sensor 1
Possible causes- Front Heated Oxygen Sensor Bank 1 harness is open or shorted
- Front Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Front Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks

I am not really sure what is going on here with the same O2 sensor giving these lean and rich codes, if nothing else is apparent and the engine runs well you may have a defective O2 sensor.

1) make sure there are no leaks / loose hoses in the air intake system 2) Clear the MAP sensor which is to the front of the passenger side of the car just under the hood. Big square thing inline with air intake. 3) Get a known good MAP sensor and see if code is still happening.

try shifting while trans is in neutral-might be bound up at the servomotor-