Removing radiator from 03Chrysler Town&Country

Gary Queen

• 85 Answers
• Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.

SOURCE: fuse for stereo/cd in chrysler town and country minivan

Its in the box next to the battery and i had the same problem.The fuse is on the first line top.

Thanks

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

SOURCE: 2002 Chrysler Town & Country Evaporator leak

THERE ARE SEVERAL EVAP HOSE LEAK SPOTS ON THESE VEHICLES..UNDER VEHICLE BY EVAP CANISTER,UNDER AIR CLEANER..ALSO LDP VENT VALVE NOT HOLDING VACUUM WILL SET A LEAK CODE..SMALL BLACK VALVE WITH A HOSE ON EACH END WITH A SMALL VACUUM HOSE ON TOP..IT SHOULD HOLD VACUUM WITH HAND HELD VACUUM PUMP..HAVE ALSO SEEN SPLIT HOSES NEAR EVAP SERVICE PORT LOCATED NEXT TO AIR CLEANER HOUSING