Seat belt stuck will not come out on passenger side

If the passenger side seat belt in your 2013 Chrysler 200 is stuck around the headrest, it could be due to a variety of issues. Here are a few things you may want to try:

1. Check the seat belt retractor: The seat belt retractor is responsible for pulling the seat belt back into the housing when it is not in use. If the retractor is faulty or stuck, it could cause the seat belt to become stuck. You may be able to fix the problem by gently pulling on the seat belt to try and free the retractor.
2. Check for debris: There may be debris or a foreign object stuck in the seat belt mechanism, causing it to become stuck. Carefully inspect the area around the seat belt and try to remove any debris that you find.
3. Check the seat belt latch: The seat belt latch may be faulty or stuck, causing the seat belt to become stuck. You'll want to check the latch for any visible damage or problems and try to release it.

If you are unable to fix the problem, I recommend having a qualified mechanic diagnose and fix the issue for you. Seat belts are an important safety feature and it's important to ensure that they are functioning properly.

You can't it is not designed that way. The seatbelt mechanism is damaged and needs to be replaced.

any luck with this? I've had the seat belt stuck in my rear sliding door for weeks! Haven't been able to open the door at all ????

below the link to fix the civic seat belt but you can request to fix your seatbelts it's 40 dollar and it will be working again

sensor may be stuck inside your seatbelt. spray a lube inside it and put it together and take it apart 5 or 6 times just to get it to loosen. do this to the passenger side as well. if this doesnt work then some cars have a sensor built into the seat that tells the car you have a passenger that isnt buckled. its possible that this sensor is stuck. should be located under seat but can be checked by simply buckling the passenger seat belt and seeing if the light goes out.

move the seat back to release tension on the belt buckle and then undo it.
Does that help? If not reply.

Remove the panels to the belt, normally these can miss roll and get stuck. Unbolt the unit so you can get some slack that should be enough to release and pull it back out to correct it. If that will not do it get a replacement from a junkyard and replace.

More than likely, you have a broken wire or two between the body and the driver side front door. This is a very common issue with those cars when tey get older.

it is you have to remove belt to get seat up the tab that keeps belt from retracting too far came off

It could have twisted on recoil and is now stuck. You'd have to remove the interior panel to view that.

On the really bad side, the seat belt pretensioner could have failed or fired and locked the belt in place. If that's the case, I'd have a mechanic replace it since you can trigger an air bag deployment replacing it yourself.