Trying to remove the starter in a 1993 toyota paseo???

Vehicle Won't Crank Due To Starter : Toyota Paseo ...

repairpal.com > Problems > Toyota > Paseo

Engine Won't Crank Due To Starter on Toyota Paseo ... My car is turning over, getting gas and all my spark plugs have fire, but it will not start. Wh... 1993 Toyota Paseo ...car won't start, problem isn't starter but i think it's in the wiring. i can start ...

Paseo Fuel Filter Help - Toyota Nation Forum : Toyota Car and ...

www.toyotanation.com > ... > Tercel, Paseo, Starlet, and Sera Forum

Mar 11, 2009 - 7 posts - ‎3 authors
Does anyone have suggestions on how to replace the fuel filter on a 1993 Paseo? ... I started trying to get at the filter which is located against the firewall ... as I need to unplug some electrical connection, which isn't budging, ... 1993 Camry LE 2.2L Won't Start - Help!
15 posts
Feb 6, 2012
Please Help! Gas Gauge Stopped Working
13 posts
Nov 29, 2010
93 corolla 1.8 automatic won't start help!
15 posts
Jul 26, 2009
Fuel pump not getting power (1989)
3 posts
Sep 11, 2007
More results from www.toyotanation.com

If you only get 1 click per key turn, sounds like the copper contact plate in the starter solenoid is worn. If you keep trying to start it and it eventually turns over click after click, then it more than likely time for a starter, or a starter rebuild if you're handy. The kits are available online for under $40

Hi,

You could see the loation of the starter on the bell housing of your transmission.
Just follow the big diameter positive(+) cable, going down into the transmission, at the end of that cable is the starter assembly. Easily reconize with a rounded tube on top with wire connected on it.

Hope that helps you out!

Thanks for using Fixya!

You cant really...its a safety option. have to replace a sensor.

Check engine light can be multiple things. You have to bring it in to find the cause.

When you twist the key to start, and solenoid is working, the power goes directly to the cable on the other side of the solenoid. If the starter does not turn the engine over, and you KNOW the solenoid is good, then you have a bad cable connection at the solenoid or starter OR the starter itself needs attention. After power goes thru the solenoid, no relay is required. JUST 12 volts.

You don't need to.You need to put new contacts in the starter solenoid switch,just take the three 8mm bolts out of the solenoid cover and pull out the plunger and you will see what i'm talking about,the car has no relaly for the starter.

The starter won't get hot while the car is running. The starter only works while you are cranking it over. After running a while and the car is hot, feel if your battery is not over heating. If the vaultage regulator in the alternator is bad the battery may be overcharging causing it to over heat and not want to work when boiling. After it cools down it may work again.
I this will help.
Sam

the other option is the fuel pump or the fuel pump relay

Your second bolt on your paseo comes through the tranny and threads into the starter, It's really weird why they did that. The Tercels all mount through the starter.