- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1
Open
the hood and reach down into the engine bay for the fog light assembly.
If you cannot reach the fog light assembly from the top you may need to
get underneath the truck to reach it. Remove the electrical plug
running to the fog light ballast.
2
Remove the bulb. Unlock the fog light bulb by turning it counterclockwise and pulling it straight out of the assembly.
3
Slide
a new bulb into the fog light assembly. The part number you will need
for the new bulb will be located on the ballast or base of the old bulb.
4
Turn the bulb clockwise to lock it into the fog light housing.
5
Reconnect the electrical connector to the bulb ballast.
the fog light bulb in the 98 Grand Prix is easy pull pigtail off light turn light from back and it will come out , replace is reverse obviously , but make sure the orientation is correct on housing as there is one tab bigger than the other 2 have to look at it from underneath to see orientation of the bulb housing.
2005 Forester - It is easiest to remove the fog assembly.
1. From underneath the vehicle pry out one plastic fastener to be able to bend the light weight plastic mud protector downward. You will see the underside of the fog light assembly with one 10mm bolt directly above you. Remove this bolt. 2. From the front of the vehicle unscrew one 10mm bolt at top of fog light (this is the shorter of the 2 by the way) and pry out one plastic rivet adjacent to it. 3. Carefully remove the fog assembly and disconnect 2-pin power connector by pulling up on the release. Carefully wiggle the housing out (no force req'd). 4. Unscrew the back from the housing and replace H3 bulbs. Take care not to touch the bulb while replacing. 5. Reverse to install. Should take an hour at most.
Hi there! You have to remove the plastic under the car bumper and then slip your hand up there to remove the bulb. On some cars you can remove the 10mm blts that hold the assembly in from the front,then take the assembly out and access the bulb.
×