Need a diagram for a mazda 6 2005 drive belt. I tooh mine off and cant seem to fit it back on, its too long. I'm missing a step.

Here is one on EBay;
http://www.ebay.com/itm/New-Genuine-OEM-AC-Compressor-Kit-With-Drier-Oil-More-For-Mazda-Protege-/311598057112?fits=Year%3A2002%7CMake%3AMazda%7CModel%3AProtege%7CSubmodel%3ADX%7CEngine+-+Liter_Display%3A2.0L&hash=item488cb10698:g:VckAAOSw1DtXGp71&vxp=mtr

Need the diagram for vacuum hose that runs from fuel rail pressure sensor the back of the engine the Rotherham hose that is connected to it like a y connection comes and connect to a connection on the passenger side mine has broken off I'm losing power bad acceleration and getting the P0171 code along with real pressure codes on my 2004 Ford F150 5.4 Triton engine lariat model rear wheel drive super crew cab vehicle would like to get diagram to find out where I can order that vacuum holes

There are two types of belt, the drive belt as well as timing belt diagram. For belt routing diagram, click the link below:--- http://carbeltrouting.blogspot.com/2011/10/2001-mazda-tribute-timing-belt-diagram.html --------- This will help.Thanks.Helpmech.

Hope this helps ??

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
CLICK on the following LINK. It has several Belt Diagrams, one which will match your specific (AC/No AC, Power Steering, .etc) that you will need.
http://www.2carpros.com/car_repair_information/year/2000/make/mazda/model/protege/2000_mazda_protege_drive_belt_routing_diagram.htm

REGARDING HOW:
This depends on your particular Engine and Options (as you see with the numerous Diagram Options.)
Let me know which Diagram (they have numbers next to them) and I can give you a step-by-step instructions.

Here ya go...


Serpentine drive belt routing-GM “C and H” Bodies 3.8L (VIN 1) engine

This URL has the diagram you need.
http://www.2carpros.com/car_repair_information/year/2001/make/mazda/model/tribute/2001_mazda_tribute_drive_belt_routing_diagram.htm

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

You may have to buy a new belt because that one may have stretches. After you buy a new belt. Look at he alternator, it has two screws, one hold it in place and the other allow it ti move. Lose both a little. With a pry bar push the alternator so the belt can fit. Look for the belt routing diagram in the engine compartment. Follow it and put the belt on. You were suppose to have a belt tension tool to determine the tension. Then use your pry bar to move the alternator to position and tension then tightened alternator screws.

You'll need a 14mm socket wrench.

Locate the belt tensioner pulley. It's the one closest to the alternator and the only one that comes in contact with the back surface of the belt.

Fit the socket on to the bolt on the pulley.
Try to turn it clockwise.
This should swing the pulley down and loosen the belt,
Slide the belt off one of the other pulleys.
When it's clear, release the tensioner, remove the belt.

Same deal in reverse to replace the belt.

Here's a diagram

Hope this helps

Mike