Question about 2005 GMC Canyon

1 Answer

AC switch only work on high - 2005 GMC Canyon

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 153 Answers

The blower motor resistor went bad its located near the blower motor under the pass. side of the dash

Posted on Oct 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced the blow motor and the resistor in a 2010 Nissan sentra the ac still does not work. Fuses are good


blower motors have nothing to do with ac systems
the controllers of the ac are
high pressure switch
low pressure switch
thermostat
fan switch
compressor relay
wires and connections
ac clutch coil
If it is not working , then there is every possibility that there is no gas in the system
have a professional ac fitter properly diagnose the fault

Aug 26, 2018 | Nissan Cars & Trucks

1 Answer

On my 2006 ac works good when engine is cool, in stop & go traffic it blows hot air & head pressure gets high in ac, car temp is ok what's wrong


How do you know head pressure is high? Do you have an auxiliary electric cooling fan that is not coming on in this situation? It should be in front of the AC condensing coil. There may be a switch tied to the system that is bad. This switch is sometimes activated by the pressure in the high-pressure line to the condenser coil. If there is not enough freon (134a) the pressure will not be high enough to activate the cooling fan switch. I recently added one can to my system and it made the fan run whereas it did not before adding the freon.

Jul 05, 2015 | AC Cars & Trucks

1 Answer

I was told by A/C guy I have a short somewhere to the high pressure switch. something is not kicking on the compressor. another mechanic said I need a new computer. what do you think


go with the ac guy
there are systems that prevent the ac compressor working
high pressure switch which cuts the ac clutch if the head pressure goes too high
low pressure switch which cuts power to the ac compressor if there
is no gas in the system
climate control systems which cut power when the ac is not required
fuses to the ac system
get a better explanation or seek advice from other ac mechanics

May 01, 2015 | Cars & Trucks

1 Answer

1994 chevy 1500 ac compresssor stopped working fuse is good


couple of reasons
there is no gas in the system and the low pressure switch has stopped the ac compressor
there is too much gas in the system and the high pressure switch has stopped the compressor
there is a blockage in the tx valve and the high pressure switch has stopped the compressor
The climate control module has failed and stopped the compressor
I am thinking a leak and no gas.

Apr 16, 2015 | AC Cars & Trucks

1 Answer

96 geo tracker dash a/c switch wont work


Did you check the relay to see if it is getting power and ground ?
Is the high pressure switch working correctly ?
The low pressure switch opens when the pressure drops below 20psi, and the high switch opens when the pressure is above 300psi.

Jan 10, 2013 | 1996 Geo Tracker 2 Door

1 Answer

Location of ac high pressure cutout switch on a 97 Plymouth voyager. Could it be a different problem? Had to replaced the PCM and a couple sensors because of a short in the wiring cluster. Now the ac...


HIGH PRESSURE CUTOFF SWITCH LOCATED ON AC COMPRESSOR DISCHARGE LINE LEADING TO THE CONDENSOR.THE HIGH PRESSURE CUTOFF SWITCH WILL CUT OFF THE AC COMPRESSOR IF SYSTEM PRESSURE RISES TO HIGH CAUSED BY RESTRICTION IN THE REFRIGERANT CIRCUIT OR OVERHEATED CONDENSOR.MAKE SURE COOLING FAN IS RUNNING WHEN THE AC SWITCH IS ON.THE COOLING FAN KEEP CONDENSOR COOL, IF COOLING FAN DONT RUN.YOUR AC WILL STOP BLOWING COLD AIR.HAVE THE REFRIGERANT SYSTEM CHECK OUT.MAKE SURE YOUR LOW SIDE PRESSURE IS 10 - 37 PSI. THE HIGH SIDE PRESSURE SHOULD BE 112 - 210 PSI. CHECK THE AC COMPRESSOR CLUTCH FUSE AND RELAY.

Jul 29, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

Fan only works high speed. For AC compressor runs but no fan other than when switched to high speed at which time the fan runs at high speed but AC switches off.


I have the same problem on my 1999 Jetta have you gotten any responces yet if you do please email me the solution rohintz@gmail.com Thank you Rick

Jun 13, 2011 | 1999 Volkswagen Jetta

1 Answer

RPM Is Very High On AC Load


check the solenoid that control the engine RPM the solenoid will work if the compressor run, this will increase your rpm when AC on. location near the carburetor.

Jun 11, 2009 | Oldsmobile 88 Cars & Trucks

Not finding what you are looking for?
2005 GMC Canyon Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...