Trying to change water pump..where is location..1999 trooper

depending if it is a petrol or diesel , petrol there is one in the tank on the pick up (not commomly changed ) the one that i guess your after is on the rh side of the chassis in a bracket mounted to the chasssis will be a round cylinderical metal canister with a metal line at either end of it . you have to get under the car to change it . any problems finding it locate the tank and follow the line towards the engine and it should nt be too far away from the tank. diesel the filter is located under the bonnet with the water trap and lift pump its easy to locate

Water pump, thermostat or head gasket!

We do not have these diagrams, the info is located in the factory repair manual and that is copyrighted and not free to share because of the copyright. You can "rent" access to the manuals and all tech inf here: alldatadiy.com

Be sure to get a new tensioner and water pump. This is not a job for a novice. http://www.youtube.com/watch?v=kjhNOVl1Tcc

resistor will located with blower switch or blower motor. thanks

Try neutral start switch. Use shop manual to determine its location on an automatic vehicle. If vehicle is a stick its attached to clutch pedal via lever. To test it remove it from its connectors and make a jumper wire and jump the circuit if car starts you found your culprit.

If your car is over-heating, chances are it's the water pump or thermostat. These two parts should be changed out at the same time because if your pump is old enough to go out then the thermostat is not far behind.





Step1 First you'll need to pull out the old water pump. Look in your vehicles owners manual and find the diagram showing what all that stuff under your hood is. locate the water pump (usually underneath alternator running on the same belt) you'll need to take this belt (serpentine or other) off to start pulling the old pump. There should be a tension bar or arm that easily loosens the belt with the right size socket. Step2 Once you've gotten the belt off you can begin to remove the old pump. There should be only a few large bolts holding it in. After you've gotten the old pump out, place the silicone sealer on the new water pump 9around the edges where it meets the gasket. Then apply the sealer to the gasket as well, just use your fingers to spread it on. Now place the new pump with gasket, where the old one was, replace the bolts and be sure not to crank down too tight on the bolts or you might crack the gasket and your pump wont seal. Step3 Now that you've gotten the new pump installed, you'll want to replace the thermostat. the thermostat could be located near the water pump or on the other side of the engine. So once again, refer to the vehicles owners manual and find where the thermostat is. You might need to remove some hoses and/or lines to get to the thermostat, so just be careful not to break/bend/crack or damage anything (the older the vehicle, the better chance of something breaking) Pull the old thermostat and replace it with the new and you're all done. Don't forget to put everything (hoses, lines, nuts'n bolts) back where they came from and off you go!

the whole job takes @ 3 hours to complete. Make sure you have the gaskets and a sensor safe gasket sealant. clean all surfaces thouroughly to remove all foreign objects and the old gasket material.it's all pretty self explanatory.

no sweat buddy, piece of cake, round up ur missus sewing kit and attack with gusto!! good luck

Change the fuel pump relay....and let mee know