Key fob ford focus key fob not working

Marvin

• 85242 Answers
• Posted on May 28, 2009

SOURCE: key fob not working after battery change ford focus 2006

Try reprogramming it.

1. Turn the ignition from OFF to RUN 4 times within 6 seconds.
2. Turn the ignition OFF. The system will chime to confirm programming mode.
3. Within 20 seconds, press any button on first keyless remote.
The system will chime once to confirm programming.
4. Within 20 seconds, press any button on second keyless remote.
System will chime once to confirm programming.
5. Turn ignition to RUN to exit programming mode.

SOURCE: ford focus rs alarm trouble

if its a factory alarm you put the key in and quickly turn the key on and of i cant remember if its 8 or 9 times but the horn will chirp then you push the lock and unlock on the fob the locks should respond then turn key off and your done. note that if you have more than one fob you have to press lock and unlock on all of them before you turn the key off and i believe you only have about fifteen seconds to do so if not let me know i will look it up at work

SOURCE: how do i reprogram my02 ford focus remote locking key fob please.

get in your car close door hit the unlock button then put key in the ignition cycle the key from off to on (STOP BEFORE START POSITION) cycle key off to on 7 times after the 7th trime the doors should lock the unlock automatically that means u are in trainning mode hit the unlock button on key fob. the key fob should now work if it doesn't then try changing batt

SOURCE: focus remote key fob not working

this info would cost you £30.+ at ford Radio Frequency Programming Instructions:

• Insert the ignition key and turn from position II (Ignition) to position 0 (All off) and back four times within three seconds.
• Remove the ignition key. The locking control system is now in "learn mode" for the next 20 seconds and the red warning system LED (By the clock) stays on continuously to indicate this.
• During the 20 seconds press one of the transmitter buttons. The remotes signal and code number is learned by the locking module and is indicated by flashing the warning system LED.
• Wait until learn mode times out (20 seconds) or switch the ignition back to ON.nfrared Programming Instructions:
• Put your key into the ignition and turn to position 1 (Radio). After approximately 10 seconds the red alarm control LED (next to the clock) should illuminate. As soon as it comes on remove the key from the ignition - the LED should remain lit.
• Point the remote's "eye" at one of the front door sensors and press the rear button until the light on the transmitter illuminates (Keep the button pressed)
• With the rear button held in press the front button 4 times then release both at the same time. The control lights in both clock and fob will flash 4 times to indicate programming complete.
• Turn the ignition back on to exit programming mode

SOURCE: i have a new shape ford focus (05)i cannot open

does the hatch open with the trunk release in the car as it should since it sends an electronic signal just like the key fob. The cylinder for the trunk lock is most likely seized and if you want to replace.. you'll need to remove your trim for the trunk to access the locking assembly