The prius bluetooth does not automatically connect with the blackberry storm. The handheld is connected but not the car BT. By each new start I have to "pair phone".
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
i know the prius goes nuts when the start battery is weak . i have repplaced the start battery tewice on my Prius.both times the car wad raelly weird. one the new battery is properly istalled the car returns to normal.
Activate Audi MMI 3G bluetooth connection and handsfree profile in your car. All Audis with Multi Media Interface 3rd generation are equipped with bluetooth, some just need activation which you can do for free, without adding any hardware.
You car need to have MMI 3G system. Check your Multi Media Interface version.
Hidden menu must be enabled.
Procedure:
Turn key into II position and wait for the MMI 3G system to start. You can also use keyless buttons.
Press and hold buttons SETUP and CAR.
After couple of seconds hidden green menu will appear. You can now release the buttons.
Navigate to diagnose > settings > Tel settings misc.
Check current value in this line and switch to value with "BT/HFP" instead of "no BT/no HFP".
Press RETURN and CAR buttons at the same time to exit hidden green menu.
Restart MMI 3G with key combination
Connect your diagnostic interface with module 5F - Control Head.
Choose procedure 10 - Adaptation.
Choose Channel 17 and read stored value (should be 0).
Same here. New fault. I make a call or a call comes in. When the party hangs up or I end call ... car screen show call in profess ... sometimes it will goes back to home and sometimes not. My phone is not stuck I can make the next call. Calls ends but the highlander screen does not show call ended. The end call sound pa=lays but still screen shows it is stuck in the call ... even when using the phone to make the next call. Frustrating because this was not the case until all of a sudden. I checked for update, disconnected and reconnected etc etc
unplug the fuse for the navigation/radio for about 10 minutes then plug it back in. that should reset it. before you do that make sure you know the code to activate the radio and how to enter it (if it requires a code).
if you can't locate the fuse just unhook the battery for that length of time.
Ok, this isn't so much a solution as a work around.
As long as your phone is still holding the call (showing connected), once the Range Rover drops the call, hit the soft button that shows a picture of a green phone receiver....as if you were making a call. This will cause the Range Rover to reconnect the speakrs/mike to the phone, and you can continue your call in relative harmony.
I still haven't figured out how to get out of the jam when a second call comes in while you are still on the first....
Jealous of your car but besides that. Could you tell me the steps your going through to connect it to your car. Not some blackberries are picky (most) on what they connect to. If the blutooth in your car doesn't resemble a headset etc it may never connect.
×