Looking for a Picture of the fuel system for a 1995 Ford Explorer XLT. To find out where the fuel pump is located for my husband. Truck just stoped running last night and this happened before and the guy replaced the pump and told us to just check the pump if it would happen again. Need Picture

is this car the mazda best version? (non USA)
Fiesta-based models? Europe or the Brazilian version.
nobody ever posts the VIN of truck or country.
or the Australian (XLT pops up googled here)



so there is NO ANSWER LACKING THAT.
THIS INFORMATION IS ONLY IN THE FORD SERVICE MANUAL
FOR YOUR UNSTATED COUNTY.

Fuel pumps and relays also vary by engine that is there
NOT TOLD
not told gas (petrol) or Diesel.

The purge solenoid on a 2006 Ford Explorer XLT is typically located near the engine, often near the fuel tank.
To locate the purge solenoid:

1. Pop the hood and locate the engine.
2. Look for the fuel tank, which is typically located near the rear of the engine compartment.
3. The purge solenoid is usually located near the fuel tank, often on or near the fuel lines. It may be mounted on a bracket or attached directly to the fuel lines.
4. If you are having trouble finding the purge solenoid, you may want to consult the vehicle's repair manual or a diagram of the fuel system. You can also try searching online for images or diagrams of the purge solenoid on a 2006 Ford Explorer XLT.

Geronimo, Normally the fuel lines run from gas tank, along frame rail, then up to fuel rail into injectors.
Check the attached links,
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2006 ford explorer xlt fuel line routing Google Search

Ford Fuel Filter Replacement Change How to Do it yourself

Fuel Filter Replacement 2006 Explorer

Fuel pump replacement Ford Explorer 2005 2010 Install Remove Replace...

if it starts from aerostart the the problem is that the injectors are not getting a signal to squirt. Run the fault codes to find which sensors are not working.

I just got done dealing with the same issue with my 92 Explorer; It ended up being the fuel pump. While I changed out the fuel pump, I also changed the fuel filter; this way you are killing two birds with one stone. If you were only to change the fuel pump without the filter, you would be at high risk of killing your brand new pump.
The fuel pump is located inside the fuel tank. You must remove the tank to get to it.
The fuel filter is located just under the drivers seat on the inside of the frame rail. To replace both items, you are going to need a fuel line disconnect tool.

their isnt one on pre 1995 vehicles

HOW ABOUT THE FUEL PUMP? ALSO THE FUEL RAIL COULD BE AT FAULT OR THE INJECTORS. YOU NEED TO HAVE A DEALER TEST THE ENTIRE FUEL SYSTEM

On this website you can find fuse box diagram for a lot of old models car but not only

https://www.autogenius.info/ford-explorer-1995-2001-fuse-box-diagram-usa-version/

https://www.autogenius.info/ford-explorer-un105-un150-1994-2003-fuse-box-diagram/

For 1995 Ford Truck Explorer 4WD 4.0L EFI 6cyl the Fuel Filter is located under vehicle, driver side, below seating area, rear of engine, mounted on frame rail in fuel line.

Hope helps (remember rated this).

you have to take the fuel out of the tank to make things easy, then take the tank off the truck take the pump cover off and there is the pump