Location of ABS wheel sensor 96 Astro Dayvan 2WD

https://www.engine-codes.com/c121e_jeep.html

pass side front wheel works with abs sensor. also abs fault will turn off the sensor and the speedo.

It could be one of two things. Either a loose/faulty speed sensor on one of the wheels or the ABS module itself. I would check/clean the connectors for the speed sensors first and if that doesnt work then head to a wrecking yard and grab a "new" ABS module.

my 1989 mercedes benz 300e engine light flash on and off can any one plz tell me what the problem is my email is [email protected]

intergrated with hub and bearing assembly

Check Brake fluid level.

When the ABS light is on, the brakes should revert to standard braking.

The only time ABS should invoke is when the tires are slipping as sensed by the wheel speed sensors when the wheel locks up on any of the axles.
---
ANTI-LOCK BRAKE SYSTEMS General Information Fig. 1: RWAL brake system diagram
Fig. 2:4WAL Component locations — except 1996 models
p>Fig. 3: 4WAL Component locations — 1996 models Fig. 4: Three sensor 4WAL brake system diagram — Except 1996 models
Fig. 5: Four sensor 4WAL brake system diagram — Except 1996 models
There are two basic types of anti-lock systems available for this vehicle; a Rear Wheel Anti-Lock (RWAL) brake system and 4 Wheel Anti-Lock (4WAL) brake system. The 4WAL system has two variations; a 3 sensor system and a 4 sensor system. The 2WD vehicles will be equipped with the 3 sensor system, but the AWD vehicles can be equipped with either. The systems are easily identified by looking at the rear wheels for a sensor harness. If there is a sensor harness and thus, rear wheel sensors, it is the 4 sensor system. If the vehicle is not equipped with a harness, it is the 3 sensor system. The 4 sensor system takes it speed references from each of the wheels. The 3 sensor system takes its speed references from each of the front wheels and the vehicle speed sensor located in the transmission (2WD) or the transfer case (AWD). The RWAL system components consist of the Vehicle Speed Sensor (VSS), the Electronic Control Unit (ECU), the isolation/dump valve and the Vehicle Speed Sensor Buffer (also known as the Digital Ratio Adapter). The ECU also receives signals from various brake switches. The 4WAL system components consist of the Electro-Hydraulic Control Unit (ECHU) valve (also known as the Brake Pressure Modulator Valve or BPMV), the wheel speed sensors, Vehicle Speed Sensor (VSS) on 3 sensor systems and the VSS Buffer.

YOU DONT HAVE TO CHANGE ALL 4 WHEEL SENSORS JUST REPLACE THE FAULTY WHEEL SENSOR.YOU NEED A HAYNES REPAIR MANUAL TO SHOW AND TELL YOU HOW TO REMOVE WHEEL SENSOR.LOCATION OF WHEEL SENSOR IN HUB BEARING ASSEMBLY ON GM CARS CHRYSLER FORD AND IMPORTS WHEEL SENSOR IS ON THE STEERING KNUCKLE

Its located inside the hub.

the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only

They are not the sensors you want. The car uses the abs wheel sensors for vehicle speed. Your problem lies in the abs system , possibly the left front sensor, abs ecu or speedo cluster, Clear the code and see if it stay out otherwise you'll need to go to a trusted technician. .