I need my check engine light to turn off in my 2002 Audi A6

immobilizer relearn. might need a locksmith, mobile diagnostic or dealer to relearn security. BUT FIRST check youtube and see if there is a procedure you can do yourself. a lot of the times there is. Regards, Tim

Bring your car to an auto parts store. The will plug a box in to see what error codes are causing the check engine light. Look up the code and fix as needed, the auto parts store will help you out, usually for free.

Replace oxygen sensors and have OBII scan at any good parts store and they can reset light door you. They do the scan free

OK I would recommend going to a local auto parts store that has a scan tool for use or will do free scans on the car. This device allows you access to the computer stored codes to help pinpoint the failure. A loose gas cap will usually show up as an EVAP Leak code. If those are the only codes that you see then they can be deleted with that scan tool and the light should go off. If the light comes back on again then you have other issues that might need to be corrected. I also believe what you are seeing is the check engine light but I would reference the service manual for clarification on that. Although this light will come on if you leave the gas cap loose, there remains many other reasons this light can betriggered to come on.

You need special software.

turn signal switch most likely. But it could have a faulty flasher relay. the signals and the hazards probably have seperate flasher relays and possibly on different circuits so check fuses as well

Disconnect battery, or have dealer reset

To remove the bulb, remove screws on dahs panel instrument cluster and pull it out.

To reset the light, you will need to have it put on a scanner at part store

i) fuse box for the audi A6 is most probably on the right side close to the driver;s seat by the steering wheel.  The driver door must be open to access the fuse box.  Please check owner's manual. ii) in the 2002 Audi A6 it is fuse #37.  Please check owner's manual. iii) remove the fuse for the radio then replace fuse. iv) start the engine v) the radio most probably will reset it self but you should not have to enter the security access code for the radio. let me know how the works. thanks

Hi,

I have the same car, and also don't have a manual. I found out to set the clock, pull lightly on the dial in front of the display. The display will blink and all you need to do is twist slightly to set time, date, etc. Hope this helps! How do you love it so far??


Priscilla