-
Ford Master
4,390 Answers
- Posted on Sep 28, 2009
Re: Trying to remove door latch on 1995 thunderbird. Car...
Inside or outside latch? please rate
Section 01-14A: Handles, Locks, Latches and Mechanisms
1995 Thunderbird, Cougar Workshop Manual
REMOVAL AND INSTALLATION
Latch, Door
Removal and Installation
- Remove front door trim panel (23942) and watershield from front door (20124). Refer to Section 01-05 .
- Mark the location of the bolt retaining front door glass run front retainer (21572). Remove the bolt.
- Check all rod connections against the appropriate illustration. Correct any disconnected or loose connections and check operation before replacing parts.
- Remove power door lock actuator (218A42).
- Disconnect the rods from the front door latch (21812) . The front door latch remote control link (21940) and the latch-to-lock cylinder rod cannot be removed because of the rod's end configuration. Remove wiring from clip on front door latch shield.
- Remove front door latch control cylinder rod (22134) from the door lock cylinder (21985).
- Remove front door latch remote control and link (21818).
- Remove the front door latch retaining screws. Disconnect the door open warning lamp switch (14018) , if so equipped. Remove the front door latch from the front door .
-
NOTE: Do not damage anti-theft shield.
Remove anti-theft shield from the front door latch .
- Remove front door latch remote control link , front door latch control cylinder rods , and door open warning lamp switches from front door latch , where applicable.
- To install, reverse Removal procedure. Tighten front door latch retaining screws 4-8 Nm (36-70 lb-in).
Item
Part Number
Description
1
21852
Front Door Latch Push Button Rod
2
21940
Front Door Latch Remote Control Link
3
386656-S
Bushing
4
21978
Door Latch Shield
5
218A42
Power Door Lock Actuator
6
22134
Front Door Latch Control Cylinder Rod
7
21812
Front Door Latch
------------------------------------------------------------------------------------
Remote Control Assembly
Door Latch
Removal and Installation
- Remove front door trim panel (23942) and watershield. Refer to Section 01-05 .
- Remove screw and washer assembly retaining front door latch remote control and link (21818) to front door (20124) .
- Rotate front door latch remote control and link to remove from front door latch remote control link (21940) .
- To install, reverse Removal procedure.
×