It's so easy to replace the lights in your pacifica that even a girl like me can do it in under five minutes...
Above each light fixture are two screws, most likely they will take a flat-head or common screwdriver. Remove both of them.
The light fixture is ready to come out now. Take your screwdriver and under the front of the fixture gently pry upward and the whole assembly will pop right out. turn it over and remove the correct rubber cap for the bulb you need to replace (outside is low beam, inside is high beam. At least on my 05 anyway) Reach into the back of the fixture and turn the light and socket counter clockwise.
Unplug the old bulb and put in the new! Now just reverse the process.. Note: When putting the fixture back in place, make sure that the lip on the plastic bracket of the fixture goes over the metal frame that you removed the screws from!
Once the screws are in place, if you have not already, snap the bottom of the fixture into place and you are good to go.
Once I knew how to do it, I was able to do it in under 5 minutes and didn't even mess up my nails! lol
Good luck!
Look it over, get involved and remove whatever screws hold it to the body/fender etc. Most screws are Torx type fastners. No torx sockets or driver bits, your done before you start. Torx have been on veh for 25 years.
268 views
Usually answered in minutes!
×