Side light and tail lights not working which fuse are they on

Not for tail lights.
GeT a 12 Volt probe screwdriver with the handle that lights up or volt meter. Remove the bulb turn on tail lights clip to any good ground and put the probe tip on the bump at the bottom of the socket and it should lite up. Now clip ground to side wall of socket and probe both bumps in the center one bump is tail the other is brake. Have someone push on brakes and see if they light when on one bump then check tail on other bump. DO NOT TOUCH THE SIDE WITH CENTER PROB OR IT WILL SHORT BE CAREFUL. this will tell you where the problem is,

Also check fuse holder.
leave fuse in clip to ground turn on tail light and probe both ends of fuse for power.

Hope this helps Mike

you blew a fuse. check fuses in both fuse boxes..
ahh yes, the IP cluster lamps are dad, but not the idiot warning lights
only the parking lights in the cluster are dead. right.?
and the park-tail, running lights and dash dim lights are all the same.
my guess three is a short on the TAIL fuse, the TAIL fuse blew
and took out: park-tail, running lights and dash dim lights are all the same.
it blew. most are marked tail even thought it runs side lamps and front parking lamps... TAIL is wrong, they are parking. lamps it truth.

TAIL LIGHT NOT WORKING

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.

---------

There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----

Turn Signal Not working

http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------

Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------

Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------

Turn signals not working on 1987 Jeep Wagoneer?

http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE

http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------

1994 Toyota Camry: Bypass Tail light Relay Circuit?

http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------

2008 Toyota RAV4: Replace Tail light Lens Cover?

http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html

--------

2003 Chevrolet S10 Tail light Fuse

http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------

Chevrolet Parking light and Tail lamp light Wiring diagram

http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------

Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------

These details will help.

Thanks.

Then you need someone who can,like a repair shop

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.


---------
There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----
1994 Toyota Camry: Bypass Tail light Relay Circuit? http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------
2008 Toyota RAV4: Replace Tail light Lens Cover?

http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html
--------
2003 Chevrolet S10 Tail light Fuse http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html
--------- Chevrolet Parking light and Tail lamp light Wiring diagram http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html
---------- Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------
Turn Signal Not working http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html
---------- Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------
Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------
Turn signals not working on 1987 Jeep Wagoneer? http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------
Thesedetails will help.
Thanks.

Check for power with a test light(not a dvom) at the tail lamp assembly. Test right at the spot where the bulb socket sits. If you have power then i would check the connection tab on the bulb socket itself for pits or corroded tabs. If you do not have power present at test point then double check the fuse chart and see if it says 'electronic' instead of having a fuse amp rating for the tail lamps. If it says electronic for any of the light circuits then it means their is no external fuse that can be replaced and the problem is most likely internal of the headlight switch. Since the headlight switch is actually a power source for the lights. I would start there at this point. Let me know what you find and if you need anything else just let me know

I had this problem with my 2007 Honda CRV -- all the lights worked EXCEPT the tail/running lights and the license plate light. The other tail lights worked -- brake, reverse, indicators, and hazards. Front headlights also worked, but when the headlights went on the back tail lights did not (not to safe for driving at night!!)
The fuse was #15 in the interior fuse box (under the dash driver side) with the label "small exterior lights" ( also check fuse #19 labeled "small lights main"). The cause of my problem, I believe, is a bad or lose wire in my license plate light.

Dash lights are on the same fuse as the tail lights. Dash lights not working is an indication that the tail lights are not working. The first thing to check is that the tail light fuse is not blown. Most of the time replacing the tail light fuse will restore both the tail lights and the dash/interior lights. If this is not the case you may have to trace the wires and look for a broken or unplugged wire in the harness.

hi if it is only the one bulb not working/tail light and the front light on same side is working along with number plate and other tail lights may i suggest you replace/check the bulb on defective light as if fuse had blown ? the front light on same side would not be working if you put ignition on and press brake your brake light shoul work ? if so change the bulb as the bulb has two elements inside tail light and a higher wattage element for brake light