I have a 96 Dodge Caravan Sport with a 3.3L engine. I have OBD trouble codes of 12, 43, 65, & 55. I know what the 12 & 55 are but need help on the 43 & 65 codes. I have tried to start the vehicle and it only clicked. Please help. Thank you.

We had a 96 dodge caravan 3.3l and the filter was part of the tank the bottom. I believe this is the same thing with yours.

2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers

Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305

A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan

Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An

You will loose all data, if you clear any
OBD MIL Lamps

Gas Cap light doesn't always mean that was the problem

Those are OBD1 Codes for a 1995 & earlier vehicle

Put Dodge OBD 1 Codes into Google & see what they
refer to

I didn't see a 36

It is for the radiator fan relay control circuit.It means there is a problem in the cooling fan relay circuit.Could be the relay,wiring,or the fans.Check the fuses and relay over if it looks good then you have to take it in to get it diagnosed.You need a scan tool and you also need to know how to use a multimeter.Hope this helps.Good luck.

55 is the ending of every code so that isnt a trouble code either

po442 is evap emission control system leak (small) 1 of the lines for emissions is leaking. po455 is-- emission control system leak (large). turn off light with code scanner after it is fixed.

cycle key, on,off,on,off,on & leave it on (not start) & count flashes from check engine light to see if getting any trouble codes. example: 2 flashes, pause, 2 more, is code 22. 3 flashes,pause & 3 more, is code 33, etc.. let us know what you get, if any. P.S. Code 55 - 5 flashes,pause 5 more, is end of message.

sounds like the timing has jumped

P1494 Leak detection pump pressure or mechanical fault, hope this helps