- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
hi jerome
I have the procedure for Toyota auto lock, is worth to try it
AUTOMATIC LOCK SETTING
1) Step in the vehicle and make sure that all doors are closed completely
2) Insert the key into the ignition key cylinder.
3) Wait for more than 5 seconds.
4) After turning the key to the ACC position, turn the key from the ACC to the
ON position 5 times within 10 seconds (Last position : ON).
? Status Monitor LED will illuminate for 30 seconds.
Note : In case you implement 6 times or more by mistake,
action steps 6)-8) you made will be canceled.
Please retry from step 2).
5) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key to the ACC position.
? LED will continue illuminating.
? Indicator lights will flash 2 times.
Ignition controlled door lock ON :
6) While the LED is illuminated:
• Open and close the driver's door 1 time.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 1 time.
? LED will extinguish.
Ignition controlled door lock OFF :
6) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 2 times.
? LED will extinguish.
Chances are its a door switch or the wiring close to it. the wires bend every time you open and close the door. Check for that but if your dead set on a relay. look under the hood you should find a relay panel on the left(drivers side) finder well. On the cover of the panel box will be a listing and placement for all the relays
some will reset by locking and unlocking the door with the key.....or .need to replace the battery in the car it is dead and when u try to reset it trips again because it is dead
Sounds electrical/relay to me if you cannot lock by pressing the lock button on the door itself. Driver and passenger acting the same AND the remote all the same result point to only one culprit. Let me know how it goes and best of luck!
Well, I went to the dealer and was told that Integration relay does run both the remote locking, physical pressing the actual lock/unlock button on the armrest and dome light and door chime. I had NONE of these functioning, despite checking/replacing fuses, trying to reprogram the key, etc. I do not have the picture of the relay with me right now. Please explain the problem in little bit more detail and what did you already do try to fix it and I will see what I can do.
×