2001 Pontiac Grand Am 2.4L SFI DOHC 4cyl
Vehicle Speed Sensor - Location:
The speed sensors are built right into the wheel bearings of your vehicle, at the front and rear locations. They work
both with the anti-lock brakes and with the traction control systems on
the vehicle.
Removal & Installation
Front
The
front wheel speed sensor is part of the hub/bearing assembly. Refer to
Wheel Hub and Bearing Replacement in Front Suspension for service
procedures.
Rear
The rear wheel speed sensor is part of
the hub/bearing assembly. Refer to Wheel Hub and Bearing Replacement in
Rear Suspension for service procedures.
I hope help you with this (remember rated this help) Have a nice day, good luck.
What ever you do don't use an impact wrench when tightening up your main axle nut as I messed up my new wheel bearing sensor and my abs light kept coming on. replaced it and tightened nut by wrench and it fixed my problems. must be some sensitive components in there that don't like to be jolted. works fine now. you can get discount ones on ebay for about $50.00 that are just fine.
SOURCE: where is the wheel speed sensor located on a 2001 pontiac grand
2001 Pontiac Grand Am 2.4L SFI DOHC 4cyl
Vehicle Speed Sensor - Location:
The speed sensors are built right into the wheel bearings of your vehicle, at the front and rear locations. They work
both with the anti-lock brakes and with the traction control systems on
the vehicle.
I hope help you with this (remember rated this help) Have a nice day, good luck.
SOURCE: how do i change wheel speed sensor on a 2001 pontiac grand am se
well if it is the front wheel speed sensor it is part of the hub bearing and that hub unit will have to be replaced as one unit.
first raise the vechile and support it with jack stands. remove the wheel that has the bad wheel speed sensor.
then remove the brake caliper and mounting bracket.
remove the brake rotor.
remove the axle nut from axle.
unplug wheel speed sensor wire harness and bracket.
un bolt the three 15mm bolts on the back side of the spindle for the hub bearing unit mounting.
after everything is un bolted you will need to soak the mating surface of the hub to spindle with wd-40.
take a hammer and cold chisel between the mating surface of hub and spindle. work your self around the mating surface of the hub.
depending how corroded it is the sensor part of the hub unit may stay stuck in the spindle and if that happens use hammer and chisel to remove it.
clean the inner surface of the spindle where the hub sits and re install in the reverse procedure.
if you have any more question please ask i will be glad to help. good luck
SOURCE: where wheel speed sensor is located on 2001
2001 Pontiac Grand Am 2.4L SFI DOHC 4cyl
Vehicle Speed Sensor - Location:
The speed sensors are built right into the wheel bearings of your vehicle, at the front and rear locations. They work
both with the anti-lock brakes and with the traction control systems on
the vehicle.
Removal & Installation
Front
The
front wheel speed sensor is part of the hub/bearing assembly. Refer to
Wheel Hub and Bearing Replacement in Front Suspension for service
procedures.
Rear
The rear wheel speed sensor is part of
the hub/bearing assembly. Refer to Wheel Hub and Bearing Replacement in
Rear Suspension for service procedures.
I hope help you with this (remember rated this help) Have a nice day, good luck.
2,967 views
Usually answered in minutes!
×