How to I replace an electric drivers side mirror on a Ford Focus

Question edited for clarity.
Question moved to model category.

Fuse 46

2005 Ford Focus fuse box diagram

StartMyCar https://www.startmycar.com > Focus > Fuse box

The 2005 Ford Focus has 2 different fuse boxes: Passenger compartment fuse panel diagram. Power distribution box diagram. * Ford Focus fuse box diagrams ...

Ford Focus (1999-2007) fuses and relays

Fuse Box Diagrams https://fuse-box.info > ford > ford-focus-1999-2007-f...

Here you will find fuse box diagrams of Ford Focus 2000, 2001, 2002, 2003, 2004, 2005, 2006 and 2007, get information about the location of the fuse panels ...

..

broken cable. try operating the gearshift while looking for the operation on the transmission itself. raise hood and observe the transmission.

On the thermostat housing which is located on the back side of the cylinder head above the transmission bell housing.

The fuse box of the 2005 Ford Focus is located on the driver's side, below the dashboard. It is mounted on the firewall just to the left of the brake pedal. ---------------------------------------------------------------------------
Diagnostic VAG

no you just squeeze it around the edges to unclip the wedge shaped holding mouldings in other words when its on you will break it to take it off...

2005 Freestyle/Five Hundred/Montego Workshop Manual

1. Remove the exterior mirror trim cover.(on inside of door)
   

1. Disconnect the exterior mirror electrical connector.

1. Remove the 3 exterior mirror nuts.

1. Remove the exterior mirror.

1. To install, reverse the removal procedure.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Not that hard on this model.Here is a pic of the mirror and the removal and installation proceedure.

http://i253.photobucket.com/albums/hh43/chuck943/N0025797.gif

1. Remove the exterior mirror trim cover.
   1. Release the retaining clip.
   1. Disconnect the exterior mirror control switch electrical connector.

1. Disconnect the exterior mirror electrical connector.

1. Remove the exterior mirror bolt.
   • To install, tighten to 11 Nm (8 lb-ft).

1. If equipped, remove the exterior mirror screw.
   • To install, tighten to 2 Nm (18 lb-in).

1. Remove the exterior mirror.

1. To install, reverse the removal procedure.

pull off the black triangle panel from the inside of the door opposite of the mirror. there is a gold 10mm bolt and a 1 black torx 20 bolt. unplug the connector and fish through the new one.

Pull the door panel off, the studs are behind it.