SOURCE: 1999 ford expedition with a passenger, front window stuck in the down possition
Hi,
Initially, try to determine which fuse goes to the power window. Check and replace if necessary.
In brief for a temporary remedy just to have the window closed: remove the triangular cover at the top front of the door behind the mirror, there should be a screw there; remove the trim around the door handle another screw, remove the cover of the courtesy light at the bottom of the door, there is another screw behind that; soon as all the screws are out, lift/push up on the door panel and pull off. This would grant you access to the mechanism controlling the window. You can try closing by manually turning the motor.
Thereafter, pls determine if it is the motor or the switch(es) has failed. Replacements are available here.
Incidentally, here is a nice tutorial on repairs of power windows in general.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: 2001 malibu rear driverside window off track
Just take a phillips screw driver, and a good sturdy putty knife, and your fingers, and just pry the plastic away from the metal of the door...
Open the door first, and where the inside door handle there should be 1 or 2 screws, and one near where the handle is to open the door from the inside. Take these out first before attempting to pry off the door panel. The panel is held onto the door by plastic snaps shaped like an enlongagted tooth.
Use COMMON SENSE AND BE GENTLE YET FIRM....
Don't be surprised if you have to get a whole new window motor assembly, alot of times they come as one assembly and seperate parts do not exist. Good Luck!!
SOURCE: GLASS OFF TRACK FOR FORD EXPEDITION 1999 DRIVER SIDE
You Will Have To Remove The Door Panel And Put It Back In The Track.
SOURCE: My power window came off track
There are 2 screws just above the door handle you need to remove. Remove the plastic trim around door handle. Then starting at bottom of door panel pull out to disengage the push pin clips and work your way up both sides of panel. Then lift up on door panel to disengage the weatherstip on top of panel.
SOURCE: how to remove front driver side door panel (2000 ford expedition)
There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.
199 views
Usually answered in minutes!
×