Changing air filter in 2004 Buick Rendezvous

SOURCE: 2004 Buick Rendezvous AWD Light Stays On

Our 2002 did the same thing. Easy cheap fix! Pull the wheel off and check the wiring that goes to the wheel sensor. You will find after removing a few inches of wrap, a broken wire or two. This could be on either wheel, so check both. Fix the wires back up and you are good to go. Hope this helps!

SOURCE: program a garage door opener in 2004 buick rendezvous

I cannot find the 2004, but you can buy it from the dealer. You can download the 2003 and 2005 from this link. http://www.extendedgmwarranty.com/owners-manual/buick_owner_manuals.html

SOURCE: where is the fuse for the cigarette lighter on a

well with new vehicles today they tend to build them with no ciggarette lighter outlet instead they put two or more 12volt outlets in the vehicles

SOURCE: How to change the fuel filter in fuel tank 2006

3.4L & 3.5L Engines

1. Before servicing the vehicle, refer to the Precautions Section.
   
2. Relieve fuel system pressure.
   
3. Remove or disconnect the following:
   
   • Negative battery cable
     
   • Quick connect fittings at the inlet/outlet sides of the in-pipe fuel filter
     
   • Fuel filter mounting bracket nut
     
   • Fuel filter and drain any remaining fuel
     

The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines

To install:

1. Install or connect the following:
   
   • Fuel filter to the bracket
     
   • Fuel filter assembly to the side rail near the fuel tank. Torque the nut to 89 inch lbs. (10 Nm).
     
   • Inlet/outlet quick connectors to the fuel filter
     
   • Negative battery cable
     
2. Start the vehicle and checks for leaks, repair if necessary.
   

Testimonial: "Thank you for your reply, but my car is not the fuel filter in the fuel line underneath the body."

SOURCE: How to change thermostat on 2004 buick rendezvous

Hi there, below are the removal/installation instructions for your thermostat.

REMOVAL:

• Remove the air cleaner and duct assembly.
• Drain the coolant until the coolant level is below the thermostat.
• Remove the crossover exhaust pipe.
• Remove the radiator hose from the thermostat housing.
• Remove the thermostat housing bolts and clean any sealer from the bolt threads.

Removing the housing bolt..

• Remove the thermostat housing and gasket.
• Remove the thermostat.
• Clean the mating surfaces.

The removal and installation of the thermostat...

INSTALLATION:

• Install the thermostat.
• Install the thermostat housing and gasket.

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

• Install the thermostat housing bolts and tighten them to 18 ft. lbs. (25 Nm).
• Install the radiator hose to the thermostat housing.
• Install the crossover exhaust pipe.
• Install the air cleaner and duct assembly.
• Fill the cooling system.

Hope it helps

Testimonial: "What a fast and splendid response/solution.........."