Were the cables accidentally crossed even for a second ?
Is the new battery charged up? Try charging with an external charger. Are the cables on the correct terminals and well tightened? Are there any other wires loose under the hood?
SOURCE: HI I HAVE A 1993
Do you mean when the engine is running rough, you pull the 2nd lead out ther is no change in the roughness? If this s the case, then test the lead it might be faulty.
SOURCE: changing the tail light bulbs on a 2000 mazda 626
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
SOURCE: how do i replace the fuel pump in my 1993 mazda 626 2.5
1. Relieve the fuel pressure and disconnect the negative battery cable.
2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.
3. If not already done, detach the electrical connector from the fuel pump/sending unit.
4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.
5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.
6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.
7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.
To install:
1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.
2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.
3. Connect the fuel supply and return lines.
4. Install the access cover and the mounting screws.
5. Attach the sending unit electrical connector.
6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.
7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.
SOURCE: i need to change the 3 rear sparkplugs on my mazda mpv v6 engine?
How can I take the manifold out to change my spark plugs, in 2005 mazda mpv?
SOURCE: spark plug wiring diagram for a 1993 chevy
Distributor turns clockwise. Number 1 at 5 oclock position. Firing order is 1-6-5-4-3-2
36 views
Usually answered in minutes!
×