I am trying to remove the headlight lens to replace the bulb on my 1996 chrysler LHS. I can't remove the lens.

I think many of these systems can be reset by hooking up battery, turning the key to "ON" but not to start, wait 15 minutes, turn key off, then try to start.

Bad light switch.

Here's a video on changing your front light Judd. Chrysler Sebring Headlight Bulb Replacement

not sure about removing all that! Hard to believe.
Have you inspected the underneath of the hood to be sure?
Try a good inspection, there has to be an easier way than that. Alternatively try the parts department at your local dealer - go - don't waste tiem with a call, ask for some assistance - perhaps a diagram.
Best regards
Ck

You're talking about the headlights?
It's possible that you are turning the headlight adjustment screws?
I had a 96 LHS, and I'm sorry, I can't remember how to change the bulbs.
Usually, you can reach in behind the headlights and unscrew the sockets.

The headlight housing must be removed to access the bulbs on the back of the housing. HOWEVER!!! you must take loose the bumper on the side you are replacing. To do this you also have to take loose the inner finder and turn you wheel sharply in the opposite direction of the bulb to be replaced. There is a 10mm nut you will have to remove inside as well as multiple plastic fasteners along the inner finder and across the front under the hood. Bulb just twist out to remove once the housing is removed. Also, resist the urge to use a very large hammer. Use caution when pulling the plastic bumper out where the 10mm nut was removed, the stud can easily scratch the paint while working the housing out of its socket.

The rear lenses can be removed by opening the trunk, remove the possible liner that covers the hex nuts on on the lamp housing behind the lens assembly and remove them, remove electrical connector and replace bulb.

There should be two long screws on top of the headlight assembly itself. Remove the screws, and pull the assembly out. This will give you room to get to the bulb.

This can be done buy popping the hood and removing the bulb from the rear of the headlight housing. don't screw with the housing because, its leveled for optimal sight range.

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.