SOURCE: knock sensor dont work for 2005 dodge durango
this problem is very seldom the knock sensor, it can be the harness connector at the sensor or the engine has excessive knock which will set a code, u did not mention the particular code so hard to say, the location of the knock sensor is the lower section of the engine block, it is screwed into what would normally be a block drain plug, if u replace it u need to torque it to whatever the factory spec is or it can cause it throw another code..
SOURCE: need to replace knock sensor/ O2 sensor 04 kia rio
IT IS IN THE SIDE OF THE ENGINE BLOCK, SCREWED INTO THE WATER JACKET OF THE BLOCK
SOURCE: need to know where knock sensor is located on a 2001 kia rio.
At center rear of engine compartment, by intake manifold support bracket.
SOURCE: knock sensor replacement
Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.
133 views
Usually answered in minutes!
×