Remove the seat belt mounting bolts at the bottom. Then there are 4 retaining clips on the top that get released by using a flat bladed screwdriver between the seatback and the upper shelf. Push down to release them.
SOURCE: 2002 Cadillac Coolant sensor
The engine coolant temperature sensor is located on the driver side of the engine near the rear of the engine compartment
SOURCE: How do you remove the rear door panel of the 2002
To not damage the plastic tabs that keep it flush against the door skin, pick up a tool like this:
You can get this at any autoparts store. Makes removing the panel easy!
Remove all screws and then pop the fastners all around the door panel. Remove slowly but use a little force to get it off...lifting up and clearing the door handle. Voila....it is off.
SOURCE: 2002 Cadillac Sedan DeVille door panel, how do you
I need to repair power window track cable on my car on the driver's side~
2002 Cadillac Sedan DeVille
SOURCE: HOW DO YOU CAHNGE THE THERMOSTAT ON 2002 CADILLAC DEVILLE
The most common overheating problem with the Northstar engine is a blocked purge line. It's job is to purge air out of the cooling system.
There is a small diameter hose coming from near the top of the coolant tank,this is the purge line.
With the engine idling,pull the purge line from the tank,if there is no coolant flow from this small hose,it is blocked and this will cause overheating.If the hose is clear, check for blockage at the nipple on the tank.Or trace the hose back until you find the blockage.The hose goes in to the engine to a crossover and comes out the other side to near the thermostat housing,the blockage may be there.
SOURCE: how do you remove the rack and pinion from a 2002
set steering whell straight. push rubber boot up there is a 12mm/7-16 bolt that connects the steering shaft to the rack and pinion removeboth fron tires remove p/s lines and all other fastners for the rack and pinion
46 views
Usually answered in minutes!
×