95 audi a6 Front Bumper Cover??

Should be up under the front bumper cover by the fog lights. Remove the front bumper skin to replace. Check youtube for videos of how to remove or a service manual. Requires removal of the headlights, under splash guard among other things.

Its fitted by screws and held by assembly.Give proper support to lower side and loosen the screws and bumper should easily come off.
---------------For complete step by step details,go through the help links mentioned below :-----

How to Attach the front bumper cover to the fender on 2010 Ford Explorer?

http://technoanswers.blogspot.com/2012/01/how-to-attach-front-bumper-cover-to.html
-----------

How to replace Bumpers on Acura Car models?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-bumpers-on-acura-car.html
-----------

How to Replace Front Bumper on Audi A4 and VW Passat?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-front-bumper-on-audi-a4.html
----------These will help.Thanks.

There is a simple procedure to do that.And basic tools are required.

Click the link below for detailed procedure:----
How to Replace Front Bumper? http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-front-bumper-on-audi-a4.html

-----------
How to Replace a Front Bumper Cover? http://technoanswers.blogspot.com/2011/07/how-to-replace-front-bumper-cover.html

----------
How to Attach the front bumper cover to the fender? http://technoanswers.blogspot.com/2012/01/how-to-attach-front-bumper-cover-to.html

--------------

How to replace Bumpers?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-bumpers-on-acura-car.html

--------------
This details will help.
Thanks.

hey i got a audi a6 there is a hose clamp behind the bumper cover you'll have to look under the car in that corner. see if the hose came loose or the clip cam off of loose. you may have to remove your bumper cover to have better access to the hose.

have 96, 95 similar

Section 01-19: Bumpers 1996 Villager Workshop Manual
REMOVAL AND INSTALLATION Bumper and Bumper Cover Front
Removal

1. Raise and support the vehicle.
   

1. Remove the RH and LH front wheel (1007).
   

1. Remove the RH and LH front fender splash shield screws. Remove the RH and LH front fender splash shields (16102).
   
   
   
   
   

1. Remove the four front fender brace screws.
   
   
   
   
   

1. Remove the two front fender brace nuts.
   

1. Remove the two plastic screws.
   

1. Remove the seven clip buttons located under the front bumper cover (17D957).
   
   
   
   
   

1. Remove the RH and LH front turn signal lamps (13369). Refer to Section 17-01 for the removal procedure.
   

1. Remove the four front bumper cover brace bolts.
   
   
   
   
   

1. Remove the front bumper cover from the vehicle.
   
   
   
   
   

1. Remove the two front turn signal lamp wire harnesses from the front bumper (17757).
   
   
   
   
2. Remove the eight front bumper bolts.

1. Remove the front bumper from the vehicle.
   

The bumper itself is a metal bar beneath the cover. You will have to access the underneath of the vehicle and remove the bolts holding the bracket for the bumper. Depending on the model make sure any light are disconnected first. Once the bumper is off you can remove the bumper cover and replace new bumper support

No, they are not. THe A4 and the A6 chassis are different, the bumpers have a similar style and look to them, but they are not interchangable.

its just the bumper cover.. once you buy the bumper cover it will replace your broke one,, however you my need to buy a bumpercover support..i think its only about $30 more..good luck keith...

two bolts through middle(allen key)they are about halfway along you will see them if you look underneath near edges of number plate.....