At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
might try spraying white lithium grease on the slides and open and close few times my g6 did the same thing grease it and open and closed a few times then it work
Question: does the sign IMMO (yellow) light disappear after some seconds of ignition turned on? If not you may have to close your car with your keys, than open them with the keys, than start your engine.
Should work if you are experiencing the above problem... Just an idea.
spray WD40 on it, and try to work it into the mechanism with a toothbrush. This is a solvent and a lubricant, it may loosen it up by melting any dirt stuck in there. After an hour wiggle all the moving parts and see it loosens up and can move ok.
According to the 2003 owner's manual (2004 should be similar) there is a specific procedure for calibrating the moon-roof's controller. The electronic controller may have lost its calibration settings due to an electrical glitch or disconnected battery.
Look up he exact procedure in your owner's manual as it may vary between different mdel years or OEM moon-roof suppliers.
open the light box under the sunroof the you will find the sunroof engine and gear . open the tree screw end pull it a little .now pull off the sunroof check if the both side are in the same position .if not pot them in the same position you will bee able to do this because the engine is not attached .now close the tree screw .it should work .but maybe you will have to adjust the engine and the sunroof ,because the sunroof is not open until the end or the opposite .you can do this bay moving the engine when it is not attached to the right place .
tilt the sunroof into vent position as far as possible then press and hold the same switch for 30 seconds until you see it move release the switch and immediately press and hold it again the sunroof will close and open fully then close again do not release the button until it reaches the closed position for the second time.
×