1997 toyota land cruiser engine light is on, the computer diagnostics suggest EGR code problem but EGR has been replaced, now the dealer say EMU must be replaced...this has been dianosed by 3 different certified toyota dealership shops...
Check for
vacuum leaks on intake manifold,
the air tube between the air filter.
intake manifold vacuum hose.
===
clean throttle plate with Berryman carburator cleaner
SEE sample picture HERE
===
Also remove carbon built up behind the EGR valve and the EGR passage tube.
===
Vacuum leak WILL offset the intended 14.7 to 1 air fuel ratio.
More un-metered air (leaks) will lean out the fuel mixture.
Use small amount of Berryman carb clearer at potential air leak area will help you identify trouble spot.
At idle,just spray and listen for the RPM surge.
The in-rush of carb clearer will increase the RPM on the motor.
Record the problem spot(s) and address it later.
===
EGR carbon built up require 2+ hours to clean from start to finish.
You will need a new EGR base gasket before your start.
Locate and remove the EGR valve after the vehicle is cool down.
Carefully record the connector and vacuum line (for older vehicle) location by drawing an easily to follow diagram.
Remove the EGR valve.
Inspect the location of the carbon built-up inside the valve and the EGR passage tube.
SOAK these areas with WD-40 spary.
You will need a small screwdriver,cloth hanger and lot of newspaper and time to get this cleaning done right.
RE-SOAK the carbon and let it sit for over-night will also help.
One the last round,pass a shop vacuum of the EGR valve and the passage pipe.
Install the new EGR gasket and connectors.
Allow the vehicle to warm up outdoor to burn up any remaining WD-40.
Take it for a test drive.
Please rate my answer if it's useful to you.
Cheers,
Mustgo
The egr passage in the intake might be plugged with carbon if the code is for egr flow problem,start there,hope this helps
Hello
The engine
and automatic transmission in this vehicles drive train
are fully electronically controlled by a computer called the PCM
(Power Train Control Module). Whenever a problem like this occurs the
computer stores a record of the problem (there are of course some
exceptions to this, like the fuel pump, engine coolant temperature
sensor and MAF sensor for instance) in the form of a fault code in
its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A
TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR
HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
376 views
Usually answered in minutes!
engine light on but the code reads EGR but this has already been replaced along with hoses and other components close to the egr unit (ie: vacumm part, hoses cleaned or replaced ) this has been diagnosed by 3 different certified toyota repair shops. the last shop telling me to replace the emc (computer)
the engine runs great and all symptoms are normal except for this light being on. thank you for your help.
give me the egr code.
×