There's no inertia switch in this vehicle.
The 80 amp fuse gets battery on one side and the alternator B terminal on the other. I hope this helps. Take Care.
SOURCE: 1198 kia sephia
hi
it locate behind the engine near the flywheel of transmission and engine junction block
SOURCE: location of computer on 2000 sephia
the ECM (computer) is located below right center of dash .
J5
SOURCE: Where is the fule filter located on a 1997 Kia
Following the fuel line is always the way to find the filter. It is just forward of the passenger side rear wheel. It is connected to three lines with quick disconnect fittings. You don't need any special tools to remove them, just push in the flat buttons on either side of the connectors. When you put the lines back on, just push them on firmly, and then check to see if they are all the way on by pulling them as if to remove them again. Good luck and hope this helps.
SOURCE: Location of fuel inertia switch for 1997 Dodge
i would guess by your question that you are used to Fords. Chrysler vehicles do not use these switches. just pressure switches and fuel pump relay. from relay power then goes right to the fuel pump.
149 views
Usually answered in minutes!
Having trouble with what wires go to the fuse box and how it's distrusted. Would the positive go to both sides of the main 80a fuse? Or is the inner side of the fuse connect to the altinator? It's a 1997 kia sephia rs 1.8L standard.
×