Hi Vicky. I'm Tim Dorton. Nissan calls the radio fuse" audio". It's in the passenger side fuse box.https://www.autogenius.info/nissan-frontier-1997-2004-fuse-box-diagram/
SOURCE: 2004 nissan frontier crew cab radio
the plastic around the gear shifter will pop up with a good pull, then turn it side ways to get over the shifter, then there are 2 screws the hold the bezel down around the radio and air vents, then just pull from the air vents it will pop off to reveil the screws to the radio
SOURCE: How to get in to replace a rear tail light stop
look for screw inside the bed area, adjacent to the tailight covers. Remove two screws, and the taillight assembly pulls out
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
286 views
Usually answered in minutes!
×