How do i get to fan resistor on peugeot 206 2006. I need this fixed like yesteryear due to the fact that everytime it rains my windows get fogged up and of course i cant see.

Sorry can't give you the exact location - just wanted to mention the resistor gets hot in use and in order to keep it cool enough to prevent melted plastic and possibly fire it is sited in the heater air intake, often before the fan.
Peugeot have possibly been the only manufacturer to use a solid state motor speed control instead of the resistor so don't be surprised if the resistor when you find it, is a large power transistor...

Several of the Peugeot cars I have dealt with have the fan motor and speed control resistor/unit behind the dashboard above the passenger footwell and is easily accessible after removing some air trunking. I can't comment about whether that is where it is found in your vehicle.
Final thought; over many years I have found the fan motor to invariably be the heater trouble with Peugeots and have never needed to replace the speed control resistor or whatever. Due to the dust and dirt they gather the motor bearings become tight and semi-seized so the motor turns slowly at low speed settings or not at all...

Hope this helps.

If youre talking about the blower motor then its either a bad switch or resistor

I have a Toyota and they are not good at fog. go to parts store and rained makes a product fog x easy to apply you apply on the inside its about5 bucks or less it works

You need a new fog light as you one is cracked some where you can remove the light by taking the inner wing off then remove the light by the torques bolt at the top

Hi,
There is a blower motor resistor , located in the air duct coming from the blower assy. This will have 4/5 wires attached which determine the speed of the motor blower. This will determine the fan speeds depending on the resistor combinations selected. Sometimes the fastest blower speed will work because it has no resistance and gets full voltage.
You can also check the plug going into the fan assy , the plug may have reecieved a knock from a foot and become loose! A circuit tester will be a great help also . Good Luck

to clear the interior of fog you must put the fan on recirc and #3 fan position.with the a/c on HOT.it will clear as soon as any heat from the engine is allowed to the heater matrix to dry out the interior.if you allow fresh air into the car with fogged up glass,they will get worse as the temp is warmer inside the car than out.(they collect condensation).

check the filter<hemodifier>, i beleive you have to replace if blocked

that fan is located on the passenger side under the dash, its really easy to get to. 3 or 4 bolts and one plug to take it out. youll need to buy the fan and a the little resistor/controller thingy mounted next to and pluged in to it. all should be under $150.