It is the 4 cylinder model
SOURCE: 2005 Subaru Baja Crank Shaft Position Sensor
is there a problem using e10 ethonal in a subaru impreza wrx 2003
SOURCE: location of crank position sensor 2003 santa fe 4
hi the sensor is in with the timing belt. You will have to remove the timing belt cover and belt to put a new one in. You will also see a small gold metal rotor that spins on this sensor also replace that or it will trash the new sensor.
SOURCE: car won't start
Some thing is not back together correctly. How aout the ground wires on the intake. These are a must. Check for spark and fuel. Hope this helps
SOURCE: crank shaft position sensor located hyundai sonta 2004 v6
On a 2.7L it is located above and to the right of the starter. You will have remove the starter heat shield to gain access to it.
SOURCE: Where is the crank shaft positioning sensor
Look at the area around the crankshaft pulley. It's bolted to the block and senses the crank position. If it fails, You won't have an ignition spark. Good Luck, Ned
551 views
Usually answered in minutes!
×