RTM ,. read the shop manual first.? its all there to read 24/7.
Is this car A USA CAR?
generic.
now out of shop manual quoted SX4 , near.
1) Relieve fuel pressure in fuel feed line according to
"Fuel Pressure Relief Procedure".
2) Disconnect negative cable at battery.
3) Remove fuel filler cap.
4) Insert hose of a hand operated pump into fuel filler
hose (1) and drain fuel in space "A" as shown in
figure.(this car has check valve at tank inlet)
Hoist vehicle, and remove clamp (2), fuel filler hose
(1) and breather hose (3) from fuel filler neck.
6) Remove exhaust center pipe referring to "Exhaust
Pipe and Muffler Removal and Installation in Section
1K".
7) Remove propeller shaft (For 4WD model) referring to
"Propeller Shaft Assembly Removal and Installation
in Section 3D".
8) Due to absence of fuel tank drain plug, drain fuel
tank by pumping fuel out through fuel tank filler.
Use hand operated pump device to drain fuel tank.
Disconnect quick joint (fuel pipe) (1) from fuel pipes
(2) referring to "Fuel Hose Disconnecting and
Reconnecting".
10) Support fuel tank (1) with jack (2) and remove its
mounting bolts (3)
Lower fuel tank a little as to disconnect wire harness
at connector (1)and ground wire (2), then remove
fuel tank
SOURCE: NEED HELP DO i NEED TO REMOVE PICK UP BED ON A
no way its better to drop the tank down only two straps versus 6 very rusted bed bolts. at most you might have to remove the driveshaft.
542 views
Usually answered in minutes!
×