SOURCE: 1998 dodge ram 1500 4x4 stereo wiring
glad you posted what colors you do have , cause 2 resources didn't match ,actually 3 , i did find a match to your colors was a 97 year model premium radio, so we have a match .....
black/ light green = ground
dark green = left front spkr +
purple = right front spkr +
blue/white = right rear spkr -
brown/blue = left rear spkr -
brown/yellow = left rear spkr +
blue/orange = right rear spkr +
black/yellow = park lamps
brown/red = left front spkr -
orange = dimmer signal
pink = fused battery +
green/red = radio choke relay
red/white = fused ignition
blue/red = right front spkr -
cheers
djmac62 is also an excellent answer
SOURCE: 99 silverado fuel pump
GRAY IS FUEL PUMP, PURPLE IS FUEL GAUGE, BLACK IS GROUND,ORANGE WITH BLACK GOES TO COMPUTER.GREY WIRE WITH KEY ON WILL BE BATTERY VOLTS FOR TWO SECONDS UNLESS CRANKING ENGINE OVER.PURPLE WILL REMAIN ON WITH KEY LESS VOLTS THOUGH
SOURCE: need a stereo wiring diagram for my van.
Yep!
Here you go...
1995 Mercury Villager Car Stereo Radio Wiring Diagram
Radio Constant 12V+ Wire: Green/Purple
Radio Ignition Switched 12V+ Wire: Yellow/Black
Radio Ground Wire: Black/Light Green
Radio Illumination Wire: Green
Radio Dimmer Wire: N/A
Radio Antenna Trigger Wire: N/A
Radio Amplifier Trigger Wire: N/A
Front Speakers Size: 5′ x 7′
Front Speakers Location: Doors
Left Front Speaker Wire (+): Orange/Light Green
Left Front Speaker Wire (-): Light Blue/White
Right Front Speaker Wire (+): White/Light Green
Right Front Speaker Wire (-): Dark Green/Orange
Rear Speakers Size: 5′ x 7′
Rear Speakers Location: Side Panels
Left Rear Speaker Wire (+): Light Brown/White
Left Rear Speaker Wire (-): Light Brown/Yellow
Right Rear Speaker Wire (+): Light Brown/Green
Right Rear Speaker Wire (-): Brown/Pink
That's what they show for factory
K
SOURCE: need to know how to hard wire ignition module
Ford has substantially altered their 1978-86 electronic ignition test
procedure. Due to the sensitive nature of the system and the complexity
of the test procedures, it is recommended that you refer to your dealer
if you suspect a problem in your 1978-86 electronic ignition system.
The system can, of course, be tested by substituting known good
components (module, stator, etc.)
This system, which at first appears to be extremely complicated,
is actually quite simple to diagnose and repair. Diagnosis does,
however, require the use of a voltmeter and an ohmmeter. You will also
need several jumper wires with both blade ends and alligator clips.
The
symptoms of a defective component within the solid state system are
exactly the same as those you would encounter in a conventional system.
Some of these symptoms are:
- Hard or no starting
- Rough idle
- Poor fuel economy
- Engine misses while under load or while accelerating
If you suspect a problem in your ignition system, first
perform a spark intensity test to pinpoint the problem. Using insulated
pliers, hold the end of one of the spark plug leads about
1
/
2
inch; (12.7mm) away from the engine block or other good
ground, and crank the engine. If you have a nice, fat spark, then your
problem is not in the ignition system. If you have no spark or a very
weak spark, then proceed to the following tests.
Tell if you are talking about this ignition system...
Hope this help.
51 views
Usually answered in minutes!
×