SOURCE: how to add transmission fluid to a 2005 mini cooper
The transmission is sealed, sounds crazy but it is true.
SOURCE: how to add auto transmission oil in 2005 mits montero
The Fill point is the Tranny Dipstick Tube, If you do not have a Dipstick Tube to Check the Tranny Fluid, You will need to get the Tranny Serviced from the Dealership or a Transmission Shop. On most of the Newer Imports they are ALL going with a Non Servicable Transmission that has to go in for Service. I know, It is REALLY Stupid! Please Rate My Response! Thanks!
SOURCE: where is the Transmission fluid dip stick to add
Hello and Welcome to Fixya,
Very sorry Sir, as far as I know. The Dip stick is not included in this model. The transmission fluid must be checked only by the professionals at the dealership's place using special tools for the job (so that the unit shouldn't be over runned by the user and for long life safety of the engine).
You should contact the dealer near your place for the completion of the job!
Keep using Fixya
Please Rate my solution, If found Helpful!
Regards.
SOURCE: how to add transmission fluid to a 2005 lincoln LS
H, yiour vehicle has no transmission dip stick, here is the procedure from Lincoln.
Use a OBDII scan equipment to monitor Transmission Fluid Temperature, start the vehicle and run engine at idle until fluid temperature is between 80° to 120° F (27° to 47°C). Shift through gears slowly stopping in each gear allowing it to engage. Put in PARK position. With engine running put vehicle up on hoist level as possible. Hold the larger drain plug with a wrench and remove the small center plug. Allow the fluid to drain, making sure that the fluid is between 80° to 120° F (27° to 47°C). If the fluid comes out as a thin stream or drip, the fluid is at the correct level. Reinstall the small center plug and tighten to 7 ft. lbs. (10 Nm).
You will need a special fitting available from Lincoln and screw it into where the fluid level indicator was. Add new transmission fluid to a suction gun, attach the gun to the fitting and add fluid in 1/2 pint increments, wait one minute, if the fluid comes out in a thin stream or drips the level is correct. If not add another 1/2 pint.
168 views
Usually answered in minutes!
×