Question about Buick LeSabre

1 Answer

Remove f/r fender

1997 buick lesabre custom

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Buick Master
  • 8,515 Answers

Some fixya user told me a website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Posted on Aug 26, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
dennymulford
  • 1055 Answers

SOURCE: 1997 Buick LeSabre won't start. Everything works,

bad battery connection or bad starter,or blowen fuasble link

Posted on Jun 08, 2009

  • 9 Answers

SOURCE: 2001 Buick LeSabre. How to remove headlight

the bolts you are looking to remove are located on the top of the light housing. It only takes 2 of them to remove the housing. One is about 6 to 8 inches long, and the other one is much shorter than that. Just unscrew and remove them, and pull the housing straight out.

Posted on Aug 31, 2009

Testimonial: "Thanks a bunch!"

tonycdrive
  • 2 Answers

SOURCE: 1997 Buick Lesabre Water Pump problem

THE POWER STEERING PUMP PULLEY --- ARRGGH...Not a problem. The power steering pump is held by two bolts. Use a socket and remove the top bolt and loosen the bottom bolt. Be careful not to completely remove the bottom bolt. The PS pump will loosen up enough so that you can push it towards the firewall and you will JUST have enough room to remove the waterpump bolts. Its tight but it will squeeze out.

Posted on Dec 16, 2009

daves944
  • 1050 Answers

SOURCE: abs & traction light on 1997 buick lesabre

This is a fairly common problem, Gm has actually issued a service bulletin regarding this repair. The problem probably originates from one of your wheel speed sensors that is mounted inside one of your front wheel bearings. To be sure, you need to have the car scanned to find out which one and then you have to replace the whole bearing assembly because the sensor is integral to the bearing. The bearing is not hard to do but you will need some professional tools if you want to do it yourself. At a shop it should cost between 3 and 400 dollars complete.

Posted on Jan 10, 2010

  • 44 Answers

SOURCE: how to remove heater core on 1997 buick lesabre

pull apart the dash. go on the passenger side and there you go

Posted on Feb 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix the brake light on a 1997 Buick LeSaber.


I just did a 97 Regal yesterday and yes you are correct...the strip must be removed to gain access...depending on model you may have to remove the cushioning panel (piece of upholstery panel) on the inside of trunk lid...follow this video URL as it explains the removal better in video form than written..basically remove the 7 10mm nuts holding panel on, lower trunk lid a little and wiggle panel off, twist socket and remove to gain bulb access..install is reverse procedure ...Regal, Century and LeSabre are all same idea/setup Tail Light Change 1997 2005 Buick Century 2004 Buick Century Custom 3 1L V6

Mar 16, 2015 | 1997 Buick LeSabre

1 Answer

Passenger side front fender removal


study the new fender and where there is a bolt hole then that is where you will find the bolts to remove on the old fender . They will normally be along the top inside , at the bottom near the door and around the bumper and up the panel that the door hinges are attached to

Jul 20, 2014 | 1998 Buick LeSabre

1 Answer

Buick LeSabre 1997 how to remove passenger side front fender?


5 or 6 bolts on top one on bottom usually have to open passenger door to see it one bottom front bumper may hide it

Jul 18, 2014 | 1997 Buick LeSabre

1 Answer

How to change a starter in a 1997 Buick LeSabre custom, it seems to have a crossmember underneath and an engine shock in front


Hello: Disconnect the battery, Remove the rock shield (black plastic). Disconnect the wires, remove the two bolts at the rear (driver side) of the starter and bring it out Pull forward, tilt it down it should come out

Jan 14, 2011 | 1997 Buick LeSabre

1 Answer

Where is the starter relay for a 1997 Buick Lesabre custom?


It should be located in the Fuse box under the hood or mounted on the fender wall drivers side under the hood.

Oct 03, 2010 | 1997 Buick LeSabre

1 Answer

1997 buick lesabre idle sticks


check for a vaccum leak!!!!!!!!!

Dec 28, 2009 | 1997 Buick LeSabre

2 Answers

1997 buick lasabre custom high idle, transmission, stalling


Try cleaning your grounds under the hood: under Ignition Module bracket, rf fender behind battery and lf fender in front of windshield washer fluid bottle.
I had similar problem and this fixed it.....grounds are very important for computer.
I used a carbon conductive grease on the connections to keep them from oxidizing.
Hope this helps you out.

Jan 09, 2009 | 1997 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...