Question about Hyundai i10

Open Question

I have a 2014 grand i10 and I cannot find the glove box clips to lower glove box so that I can change the aircon filter. Please advise.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic

Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually

Posted on Nov 04, 2008

Ad
warlock61
  • 659 Answers

SOURCE: i took glove box out and checked under right dash could not find the door to remove old air filter

there is no cabin filter in Grand Marquis

Posted on May 10, 2009

Mr BrokRench
  • 1623 Answers

SOURCE: How to I replace the cabin air filter in my 2008 MC C300

Remove the three torx screws using a torx-20 screwdriver...pull back the padding in the footwell...there is tab holding the left part of the plastic piece, use a flat-head screwdriver to pop it out...you may need to disconnect the light connector, and the cigarette lighter connection.. Once the plastic piece is out, you will see a large white box, the filter is inside this box. There are two yellow clips that need to be slided to the left/right. The box then pops out from below and the folded-filter will fall right out
Good luck..i hope this helps..please rate me a fixya.

Posted on Aug 02, 2009

  • 1168 Answers

SOURCE: cabin air filter (a/c filter)

Hello Oldgzr.
You were on the right track, it is behind the glove box.
Here are the instructions from the manual.


  1. Remove the lower glove box bin from the instrument panel
  2. Disengage the two retaining tabs (1) that secure the particulate air filter cover (2) to the passenger side of the HVAC air distribution housing (3) and remove the cover.
This is the cover behind the glove box that needs to be opened.
4042603.gif

Posted on Mar 30, 2010

  • 1 Answer

SOURCE: The lower glove box on my 2009 Rav4 won't close.

I had the same problem with my 2009 RAV4 lower glove box. I removed the box by popping the top front right post and then the top left front post from theside housings by prying them free with my fingers. They pop out easily. I then let the box fall open and while holding it level to the floor, pulled forward, released the piston from the post on the right, and the glove compartment came out without tools. There was a plastic electrical box cover, which came loose behind the glove box, blocking it from closing. I snapped the cover plate back in place and then reversed the glove box removal process. It took a few minutes and I needed no tools.

Posted on Dec 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing peugeot tepee aircon filter


Most are behind or below glove box.

Jun 23, 2015 | 2010 Peugeot Partner Tepee

2 Answers

How too change cabin air filter on2012 buick verano


Remove the glove box from the instrument panel. Behind it is an access door. Remove the cover and the old filter, put in the new filter. Replace cover and glove box.

1_26_2013_7_28_10_pm.jpg


1_26_2013_7_28_32_pm.jpg


1_26_2013_7_28_59_pm.jpg


1_26_2013_7_29_13_pm.jpg


1_26_2013_7_29_30_pm.jpg


1_26_2013_7_29_59_pm.jpg

Dec 29, 2012 | 2012 Buick Verano

1 Answer

How to change cabin filter 2011 Lacrosse


I just changed mine yesterday and these tips listed above were unfortunately incorrect.

Step 1 - Open the passenger door
There is a panel that has no screws on the flatside of the dashboard which faces against the closed door at the jam side. Use a body tool and pry the panel carefully exposing the inside area of the glovebox. If possible dont do this in cold weather because the tabs are plastic. Inside the panel you will see one small tab that the glove box has a 1/4 plastic clip seated in the tab.

Step 2 - Open the glove box. Remove the 3 hex screws on the top interior row of the glove box.

Step 3 - At the right and left corners of the bottom of the glove box remove the two front facing screws on the lower hinge.

Step 4- At the very bottom parallel to the floor there are two more hex screws remove those (they hold the plastic vent in place underneath the glove box. Pull the vent downward to release the tabs.
IMPORTANT: Dont forget to go back to step 1 and pull the small tab from the slot in the dashboard cover area ( Inside the panel you will see one small tab that the glove box has a 1/4 plastic clip seated in the tab)

Step 5 - Pull down on the glove box to release the clips.

Step 6 - You will see a black box inside. There are three tabs (right, top, and left) pull them individually to remove the front facing cover. Inside you will see the air filter. Remove and have airflow arrow pointed downward.

Reverse steps to reinstall. Be sure to line up the clips before pressing them back in place. Do not force them!

Good luck. I hope this helps. I did mine on the first attempt with no issues in about 10 minutes (I'm not a mechanic).

Aug 26, 2012 | Buick LaCrosse Cars & Trucks

1 Answer

How to change cabin air filter in a 2003 Subaru outback/


Your cabin filter is located behind the glove box.
First you will need to remove the glove box. Open the glove box, and on the left and right side on the inside, there will be a retainer that you will need to pull out. This will cause your glove box to fall forward, exposing all of the screws. Unscrew the 10 screws around the outer edge of the glove box, and pull the unit down and out of your way.
After the glove box is removed, you will be able to see the HVAC casing. You will see the access door to the cabin filter, held in with some clips. Disconnect the resistor connector that is in your way, then remove the four clips in order to access the filters.
Once you pull the filters out, you can install the new ones in reverse order. Make sure that the arrows on the filters are pointing up, and that the door is sealed properly when you close it back up.
Good luck and please let me know if I may further assist you. -TXTEXAN

Nov 28, 2010 | 2003 Subaru Outback

1 Answer

Change cabin air filter 2080 Subaru outback


Your cabin filter is hiding above/behind your glove box. In order to access the cabin filter, first remove the passenger instrument panel side cover. Next, open your glove box and there should be one clip on the left and right side of the glove box... remove those clips as well as the tether that is holding the glove box up. After the glove box falls forward, remove the upper storage box. You should now see the cabin filter access panel, which is held in with 5 or 6 screws. Remove the screws, pull the access panel out, and you should see the cabin filter. Reverse instructions for installation.
Please let me know if I may further assist you. -TXTEXAN

Nov 22, 2010 | 2008 Subaru Outback

1 Answer

Having problem changing air filter with 2001 Hyundai Elantra.. I know it's behind the glove box, and tried removing it, but I couldn't quite figure out how to. I did remove two clips on each side, but...


Remove the two screws holding the bracket to the back of the glove box and lower the bracket. Then remove the glove box and you can access the cabin air filter door

Nov 29, 2017 | 2001 Hyundai Elantra

1 Answer

How to replace the cabin microfilter


Hello, I'm sending you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.12eb879.gif63a72f6.gif
Thanks

Jul 27, 2010 | 2005 Nissan Quest

1 Answer

How do I change the cabin filter on my 2002 Honda Accord SE?


There are two filters.
You have the remove the glove box. Three screws on the bottom edge. Remove them, then open the glove box door. Three plastic covers along the top edge, remove with something that won't cut them up. Remove screws under them (two screws under the center one). Then, push the glove box hinges toward each other to disengage the clips in the dashboard. Then pull the glove box assembly down and out (when the box is part way out, disconnect the glove box light connector before you take it the rest of the way).
Once the glove box is out, remove the three screws (two on the right, one on the left) of the glove box reinforcement panel, then remove the panel (the bar looking thing next down from where you took the three screws out of the bottom of the glove box).
Release the snap at the bottom and remove the air conditioning filter lid.
Slide the upper and lower filter assemblies out of the evaporator housing.
Remove the old filters from the filter carriers, clean the carriers and inset the new filters.
Reverse procedure to install.
I know that this sound involved, but just take your time, and you can do it.
Hope this helps you.

Nov 08, 2009 | 2002 Honda Accord

1 Answer

I need to replace my Nissan Quest 2007 in cabin micro filter


I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.12eb879.gif63a72f6.gif

Oct 10, 2009 | 2007 Nissan Quest 3.5 Minivan

3 Answers

How do i change the cabin filter in my acura 2009 tl?


The advise by Techbuster was a bit off. The '09 is a bit different than the earlier models. To change the filter, pull the center divider in the glove box straight forward. The cabin filter housing in immediately behind it. Push the two clips on the outer edges inward and slide the tray out. Replace the filter, reinsert the tray, replace the center divider.

Sep 16, 2009 | 2009 Acura TL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...