Cars & Trucks Logo

Related Topics:

david swope Posted on Aug 24, 2019

Will removeing fuse(s) DISABLE 1997 outback legacy alarm system or how do you disable it if that does not work

5 Related Answers

Anonymous

  • 710 Answers
  • Posted on Apr 24, 2009

SOURCE: Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Ad

Anonymous

  • 1 Answer
  • Posted on Jun 16, 2009

SOURCE: how to disable alarm system

I have 96 dodge caravan and I need to disable the alarm system too and I don't know how!

Anonymous

  • 9 Answers
  • Posted on Jun 29, 2009

SOURCE: CAR ALARM DEACTIVATION

if the car only has a factory system, then you only need to insert the key to unlock the door to turn the alarm off. There should be a red light on the door panel that blinks and that should show you it's off, not sure try turning the key on the door twice. If it's aftermarket, get a replacement unit.

jimwaddelljr

  • 39 Answers
  • Posted on Jan 16, 2011

SOURCE: My alarm is activating itself.

When you close the door, the alarm will arm itself even if you do not set it. When you open the unlocked door, the alarm will sound.

Anonymous

  • 188 Answers
  • Posted on Nov 22, 2011

SOURCE: Disable alarm system

Try this http://adf.ly/3pDUa

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My dash lights on my 1997 subaru legacy outback just stopped working out of no where, What could be the problem?

ok fuse boxes are under the hood and under the dash around the hood release lever. should be the 5A fuse
0helpful
1answer

1997 Subaru Legacy Outback Wagon: Good battery but apparently it's being drained by the keyless entry or alarm system neither of which I use. I charge the battery every night and if I have several

have you tried to pull the fuse from the alarm. is the alarm a factory or after market. if it is a after market alarm look under the dash on the drivers side there will be the wires to the alarm just pull the fuse. the other thing to do is disconnect the battery every nite
0helpful
1answer

Is there a fuse or relay so i can disable the alarm system

unless the symbol on dash is light or lights flash alarm is not to blame may be sterter
0helpful
1answer

How to shut off seat belt alarm in 06 outback

are you saying that the alarm is going off when your belt is on? or you want to disable the system period?
0helpful
2answers

Lost remote to disable alarm on 2000 mercury villager how can i disable it and start my van

If you have the factory alarm system, you can put your key into either door and lock and unlock the door, that signals the computer to deativate the alarm. If you have an aftermarket alarm system installed, it will have to be removed and the wiring that the alarm ties into must be restored to factory design.
1helpful
1answer

How to disable an alarm on a 97 chrysler cirrus i lost the remote and the car wont start because of the alarm

you mare have to removel the alarm system or take it to a sevice center to replace the remote, you can try to use you owners manual to figure out which fuses run the system and try removing the fuse to it, that might work, and is worth a try, but other than that i dont know what you could do without taking it in
0helpful
1answer

The security indicator flashes twice about every 2 seconds. It does this all the time, with the ignition on or off. The alarm is activated and the system can be armed and disarmed with the remote. How can...

check your manual under security system. i think there is a way to disable it. on some outbacks there is a plug in the drivers kick panel that when unpluged the secutiy system will disable. but keyless enrty will still work
1helpful
1answer

1998 Subaru Legacy Outback with Factory issued Car alarm malfunction. Alarm will go on by itself, even when it has not been set. I want to permanately disable it!

the easiest way will be to take it 2 a subaru dealer or an auto electriction and get them 2 remove the alarm..but you could dissconnect and un bolt the external alarm siren..
0helpful
1answer

19977 buick Lesabre limited all lights come on,wont start

factory alarms have fuses too. try looking in the fuse box... remove the fuse and it'll disable the alarm...
2helpful
1answer

AWD not working

Did you know that there is a fuse under hood on Passenger side that I have seen people put the fuse in the missing spot. Problem is it is only for towing the car. Remove if fuse is present and see if it fixes your problem.
Not finding what you are looking for?

439 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...