Where is the turbine speed sensor

SOURCE: Speed Sensor

HI..
The Speed sensor on your Honda Accord 97.
Is located on the Transmission.
If you follow the Lower Radiator hose from the rad to the engine.
The hose end on the Thermostat housing.
OK.. Just on direction of the thermostat housing .
Under the housing you Will see on the transmission the Speed sensor, with a connector of 3 wires. Is the only sensor at this
Part of the Transmission..

Ok. I hope this work on your question.
Thank you for use fixya..

SOURCE: input/turbine speed sensor circuit

Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.

SOURCE: I have a code p0715, which is the input turbine speed sensor

The input/turbine speed sensor has nothing to do with the turbo. It is transmission related and is a circuit malfunction. I am having the same problem and it causes my car to downshift into 3rd gear (computer's fail safe gear) on the highway. The sensor is located above the transmission housing, and doesn't require you to take apart the tranny. I am having trouble finding the part number for this and where to buy it. Any help would be nice.

SOURCE: how do I locate the turbine speed sensor on a ford

its on the front of the transmission below the coil it compares the input shaft/turbine speed against the speed of the output sensor it is checking to see how much slip or diffrenece in shaft speeds the only time the two shafts are spinning at the same time is when torque converter is in lockup

get this sensor from ford dealer for a little more than $100 bucks

Part number F32Z7F040A

SOURCE: My 2001 Honda Odyssey D4 light is flashing, CEL

the code 0715 is Mainshaft speed sensor, check the sensor see any loose connection or replace the sensor . After replace the sensor, reset the the system. Hope this can help.