Question about Citroen Cars & Trucks

Open Question

Citroen berlingo 2009 passanger side window anti pinch activates without reason. Preventing window from closing. Anyone any idea how to reset it or deactivate the function to close the window.?

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: Driver's Side Window Won't Stay Up

As mentioned here, this worked for me on a 55 reg:

Disconnect the battery for 30 seconds. Then follow the calibrate instructions that can be found under "Windows" in the owner's manual. Took less than 5 minutes in all to fix.

Posted on Jun 01, 2009

Ad
  • 47 Answers

SOURCE: passanger side window wont work from any switch on my 406

check both door looms out for damaged wiring common problem on peugeots

Posted on Aug 06, 2009

  • 230 Answers

SOURCE: HOW DO I RESET THE ANTI PINCH ON THE FRRONT DRIVERS SIDE OF MY CITROEN XSARA PICASSO 2.0 HDI

Pull the window completly down and keep holding button for few sec. Then wind it up and keep button pressed for few secs.

Posted on Feb 19, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my citroen wont start after i changed the battery its a 2003 model


use a scan tool to reset the ECM
removing the battery activates the immobilizer and resetting turns it back on

Aug 15, 2018 | Citroen Cars & Trucks

1 Answer

Where is the starter relay by Citroen berlingo ?


The fuses are located behind the dash on driver side , u have to remove a little cover turning the screws half turn, the fuse is the F7 10 A or 20 A follow this video can find ........
Citroen berlingo fuse box relay location

Jun 23, 2018 | Citroen Cars & Trucks

1 Answer

How to change the starter motor 2009 citroen berlingo 1.6 hdi


It may be the solenoid or even the relay,, check these first .or even dirty connection to the solenoid or a LT wire corroded and no power being sent to the solenoid

Sep 03, 2016 | 2009 Citroen Berlingo 1.6

1 Answer

Market value 1983 citroen berlingo 2 door van. Manual


The Citroen Berlingo is produced by the PSA Peugeot Citroen alliance since 1996. So in 1986 it would be C15, not Berlingo.

Aug 07, 2015 | Citroen Cars & Trucks

2 Answers

HOW DO I RESET THE ANTI PINCH ON THE FRRONT DRIVERS SIDE OF MY CITROEN XSARA PICASSO 2.0 HDI


please explain anti pinch ?' new one on me and i do a lot of work on these cars

Feb 10, 2015 | 2005 Citroen Xsara Picasso

1 Answer

How do i reset anti pinch on my citroen picasso 2.0 hdi


Pull the window completly down and keep holding button for few sec. Then wind it up and keep button pressed for few secs.

Feb 10, 2015 | Citroen Cars & Trucks

1 Answer

Berlingo surges and chugs when cold.


if this is a diesel then disconnect the vacumn pipe to the EGR valve and see what it runs like

Feb 14, 2013 | 2009 Citroen Berlingo 1.9d

1 Answer

Anti pollution fault


anti pollution fault with fault codes poo87 poo93 i changed fuel filter, so far all ok.

Jan 15, 2013 | 2009 Citroen Berlingo 1.9d

1 Answer

How to remove a citroen berlingo dash board


Not very difficult once you disconnect the battery ,then remove the steering wheel and work from their following your nose for the screws ,i think the fittings that hold it in place and the heater unit are on the engine side of the firewall so you have to remove the wiper motor and the plastic trim below the screen .This is a lovely job to do and i dont envy you on this just done a peugeot 306 heater core still have the scratches all over my hands

Feb 27, 2012 | 2009 Citroen Berlingo 1.9d

3 Answers

Driver's Side Window Won't Stay Up


As mentioned here, this worked for me on a 55 reg:

Disconnect the battery for 30 seconds. Then follow the calibrate instructions that can be found under "Windows" in the owner's manual. Took less than 5 minutes in all to fix.

Mar 26, 2009 | 2003 Saab 9-3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14727 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...