SOURCE: valve clearances
Please use this link:
http://www.autozone.com/addVehicleId,1074701/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c15280045c2a
Good luck....
SOURCE: valve adjustment
tiburon uses hydrolic lash adjusters there are no valve lash adjusting If you hearing a pecking sound on the top of the mtr try some oil additive or replace the hydrolic lash adjusters
SOURCE: noisy startup when cold, sounds like valve
Hello onarock844...The Hyundai 2.4 litre and the 3.3 litre are known to have valve train noise. Some sooner than others.
The timing chain tensioners on the 06 and 07 Sonata 3.3 engines built before August 4, 2006 are well known for developing wear that allows them to make a tapping or rattling noise for a short time after a cold start. This noise can be mistaken for a lifter noise, although the actual source is in the front cover area of the engine. Hyundai has released a technical service bulletin on this problem, which describes installation of an updated design timing chain tensioner (part #24410-3C300) to correct this noise issue.
Ask your dealer to refer to Hyundai service bulletin #06-20-002 for information...If this has already been corrected,,,and the noise is coming from the upper engine area and not from the timing chain area, then the valve clearance will need to be adjusted. This is done by disassembling the valve train and installing slightly different size tappets to change clearance.
This is a fairly labor intensive process, so if you are still under factory warranty then you will want to go over the dealer's head and get the Hyundai zone rep involved to get it covered before your warranty coverage expires...
I recommend useing a full synthetic engine oil, i know in a few cases where the noise has stopped when the oil was changed over to synthenic, also a high quality filter is important, such as a purolator.
Good luck...i hope this helps...please rate me a fixya.
SOURCE: why is my hyundai i10 supplying too much fuel to the engine
Is this a diffrent type of pump then the factory pump? if so then that may be your problem and the fuel pressure is to high, or a bad fuel pressure regulator . A scan tool would be helpful to check the air fuel sensor readings along with the short term and long term fuel readings.
Testimonial: "The problem was resolved before I got your response but it helped me to confirm that what was done is correct. We actually changed the fuel pump. Thanks."
SOURCE: How do I set the valve clearances on a kia 2700
hydraulic followers should not need adjustment as it is automatically done by the oil pressure in the followers.
1,236 views
Usually answered in minutes!
×