How to remove grill from 09 avalanche - 2009 Chevrolet Avalanche

In the 2013 Chevrolet Avalanche, the horn is located behind the front grille on the driver's side of the vehicle.

To access the horn, you'll need to remove the front grille. Here are the general steps to removing the front grille:

1. Open the hood of the vehicle and locate the clips that secure the top of the grille in place.
2. Use a flathead screwdriver to gently pry up on the clips and release them.
3. Locate the bolts or screws that secure the bottom portion of the grille to the vehicle's frame.
4. Use a wrench or socket set to remove these bolts or screws.
5. Once all the fasteners have been removed, gently pull the grille away from the vehicle.

With the grille removed, you should be able to access the horn and inspect it for any damage or issues. If you need to replace the horn, you can do so by disconnecting the wiring harness and removing the mounting bolts that hold it in place.

For coolant heater, your owners manual showed this. If it isn't there, then I don't know?

lost on road somewhere...wait, no... it's invisible.

Section 01-09: Mirrors, Rear View 1999 Taurus/Sable Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 06/25/1998 Mirror, Power-Outside Rear View Removal

1. Disconnect battery ground cable (14301).
   

1. Remove front door trim panel (23942). Refer to Section 01-05.
   

1. Remove radio speaker grille from cover assembly by squeezing or pinching between thumb and index finger.
   

1. Remove two screws from cover assembly.
   

1. Disconnect outside rearview mirror wiring connector (C515-LH; C615-RH). Remove wiring guides as necessary.
   

1. Remove three outside rear view mirror retaining nuts. Remove outside rear view mirror (17682) while guiding wiring and connector through hole in door.
   

Item Part Number Description 1 17682 Outside Rear View Mirror 2 N621906-S36 Nut (3 Req'd) 3 F8DB-17D699-
AAW Cover Assembly Rear Substrate-LH 3 F8DB-17D698-
AAW Cover Assembly Rear Substrate-RH 4 N808968 Screw 5 F8DB-18B984-
AAW Speaker Grille-Standard (No Badge)-LH 5 F8DB-18985-
AAW Speaker Grille-Standard (No Badge)-RH 5 F8DB-18K901-
BAW Speaker Grille-Mach-LH 5 F8DB-18978-
BAW Speaker Grille-Mach-RH 5 F8DB-238A35-
AAW Speaker Grille-Blank (No Speaker)-LH 5 F8DB-238A34-
AAW Speaker Grille-Blank (No Speaker)-RH A - Tighten to 6-8 Nm (54-70 lb-in) ------------------
Trim Panel, Door Front
Removal

1. Remove cover behind inside door handle.
   

1. Remove screw from bottom of pull cup retaining front door trim panel to front door (20124).
   

1. Remove three screws retaining front door trim panel to front door.
   

1. NOTE: Do not attempt to remove more than one pushpin at a time.
   
   Using Rotunda Windshield and Molding Trim Removal Kit 107-R0401 or equivalent, remove the door trim panel by pulling one door trim panel pushpin at a time from the inner door skin.
   

1. Disconnect electrical connectors as necessary. Refer to Section 01-14A.
   

Installation

1. Follow removal procedure in reverse order.
   

1. Replace all pushpins with new pushpins (N808994-S).
   

Front Door Trim Panel

You will only need to remove the headlight assembly. This is done by pulling up on the two tabs at the back of the assmebly then lift up and out.

Remove the 7mm hex head screw on fender holding headlight assembly. Remove retaining clip on grill side. Reach down, twist fog light bulb to remove, unplug connector to bulb. Reverse order to reassemble. You're done. 5 minute.

solved..thanks

should be two pins running downward above the headlight try looking at it from above and see if I am correct there is two pins you need to pull up on then remove the whole headlight .. thanks Jerry holler if you need more.

If you liked the Options on the Old Truck, I would go with the 09. The Tundra is a GREAT Truck But, Will not have the Options that you Like on the Chevy. In Pro's and Con's---- The Tundra does have Better Service and a Better Warranty along with a LOT of Options FREE that you will pay Extra for on the Chevy. I have ALWAYS been Hard Core Chevy-- But, I Purchased a 2007 Scion Xa for my Wife (Toyota Built) and we have had NO Problems and there are NO Recalls and NO Customer Complaints! Just hope that the same goes for the Tundra. Chevy has had a Lot of issues and Recalls on a Lot of their Products But, I still love them! Bottom line is, Purchase what you like But, Do the Research Online first! Just type in Recalls for ............. and Search it.

no.you should see a pin on top of headlight remove this pin and light will come out and you can change bulb. it may have two pins not sure they changed around that year you will turn pin out of its holder and then slide it out if it is two they will be vertical if it is one it is horizontal