Question about Hyundai Elantra

Open Question

What do I need to do to take the cruise control from a 2004 Elantra and fit into my 2002 Elantra.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 341 Answers

SOURCE: 2004 elantra heater control only operates at #4 setting

If # 4 is the highest fan setting it might be the resistor pack that controls the fan speeds.For each speed increase the fan switch takes a resistor out of the resistor loop The highest speed is a direct connection to the battery. The switch is usually located very close to the fan since it gets quite hot and needs to be cooled by the fan.It is also generaly accessible from under the hood,but not always.Sometimes it is under the dash Hope this helps.

Posted on Dec 09, 2008

Ad
  • 2 Answers

SOURCE: 2002 Ranger Cruise Control

p 1780 tcs

Posted on Jan 25, 2009

  • 32 Answers

SOURCE: 2004 Hyundai Elantra.......Cruise control will not engage

make sure the cruise control cable to the throttle isn't too loose, if it is ok, check your brake switch. if it is sending the signal the brake is on it will not allow cruise to work and will do same thing as described about the set light.

Posted on May 11, 2009

  • 3600 Answers

SOURCE: 2004 acura Tl cruise control wont engage

This is a problem you will to take to a shop, If you are mechanically inclined I can help you, but if not I would not mess with it, it could be the button or it could be the controller and could even just be a fuse, check the fuse and if you don't find the fuse blown then let me know if you have a volt meter and what to test this yourself. You are going to be working around the air bag too and if you probe the wrong wire while testing you could break your arm or leg by deploying the air bag by accident. Or your neck.

Posted on Aug 06, 2009

  • 70 Answers

SOURCE: cruise control ford escape 2002. ford escape

If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.

Posted on May 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix cruise control?


It seems this car has a problem with its cruise control if any of the brake lights are out or even if a bulb is flickering the cruise control will not engage. I would start my diagnosis there and also the cruise control fuse of course. hope this helps

Aug 04, 2014 | 2002 Hyundai Elantra GT

1 Answer

2002 Hyundai Elantra GLS: Cruise control stopped responding. Brake lights are working. What do I do to fix the problem?


It could be something a simple as the cruise control switch(s)... or it could be the Cruise Control Module located in the engine compartment. There's also a 'clock spring' in the circuit between the steering wheel & the cruise module. Note: there are two sets of contacts in the brake lamp switch, one set for the brake lights, the other for cruise control. Properly diagnose the 'CAUSE' of the problem. Otherwise you could end up buying parts you don't need. Proper diagnosis is a 'hands-on' activity, which is nearly impossible to achieve here under the FixYa website

ghost45_39.jpg
ghost45_40.jpg
ghost45_41.jpgghost45_42.jpg

Aug 31, 2011 | Hyundai Elantra Cars & Trucks

1 Answer

My cruise control doesnt work. could it b a fuse out?


CRUISE CONTROL PROBLEMS CAN BE CAUSED BY FUSE OR FAULTY BRAKE LIGHT SWITCH OR BLOWED FUSE TO BRAKE SWITCH.YOUR CRUISE CONTROL SWITCH COULD BE FAULTY.BEST TO TAKE CAR TO DEALERSHIP LET THEM HOOK CAR. TO DIAGNOSTIC EQUIPMENT.BECAUSE CRUISE CONTROL IS ELECTRONIC AND PCM CONTROL.THE CRUISE CONTROL SYSTEM USES INPUTS FROM VSS SENSOR .SO IT WOULD BE HARD TO FIX AT HOME YOU NEED EQUIPMENT TO FIX AND TROUBLE SHOOT.

Apr 20, 2011 | 2001 Hyundai Elantra

2 Answers

How do you retrofit cruise control to a 2004 Jaguar X type 3.0 AWD?


You might want to surf the internet for Universal Cruise control kits. They are offered by TONS of auto parts chains & outlets. To fit OEM Jag cruise to yours that doesn't have (I presume) would be outrageously high dollar for parts. If you have speciality shop near you (non Jag dealer) ask them for recommendation.

Feb 27, 2011 | 2004 Jaguar X-Type

2 Answers

Hyundai troubleshooting code p0010


P0010 is camshaft position actuator malfunction. Hope that helps

Jan 15, 2010 | 2004 Hyundai Elantra

1 Answer

01 Hyundai Elantra - Cruise Control Doesn't Work w/ Headlights On


I had same problem (cruise control/dashboard lights) for the past month with my 2000 Elantra. Replace the tail lights bulbs - my problem was caused by a problem with the double filament within the bulb. Essententially, there was a short when I turned on the lights or hit the brakes.

I did this last night and everything is working properly now.

Sep 10, 2009 | 2001 Hyundai Elantra

1 Answer

1997 F150 4.6l cruise control does not work.where do i start?


Does Ford replaced the cruise control deactivation switch.
Vehicles involved in the recall include the following:

1998-2002 Ford Ranger
1992-1997 Lincoln Town Car
1992-1997 Ford Crown Victoria
1992-1997 Mercury Grand Marquis
1993-1998 Lincoln Mark VIII
1993-1995 Taurus SHO
1999-2001 Ford Explorer
1999-2001 Mercury Mountaineer
2001-2002 Ford Explorer Sport
2001-2002 Ford Explorer Sport Trac
1992-1993 E150-350 Vans
1997-2002 E150-350 vans
1993-1997 Ford F-Series pickups
1993 Ford Bronco
1994 Mercury Capri
2003-2004 Ford F0150 Lightning
1995-2002 Ford F53 motor homes.

May 15, 2009 | 1997 Ford Expedition

1 Answer

2004 Hyundai Elantra.......Cruise control will not engage


make sure the cruise control cable to the throttle isn't too loose, if it is ok, check your brake switch. if it is sending the signal the brake is on it will not allow cruise to work and will do same thing as described about the set light.

May 08, 2009 | 2004 Hyundai Elantra

3 Answers

"Cruise" on a 5-speed '00 Hyundai Elantra


I have this same car. The place you set speed control is on the windshield wiper switch on the right side of the steering column. The button with the indicator light has to be pushed in order to use the cruise control but just because the indicator light is on, it does not mean the cruise is on. Hope this helps a little. If you need more info and someone else doesn't answer more eloquently.. I'll check back and try to give you more info. :-)

Apr 09, 2009 | 2000 Hyundai Elantra

1 Answer

Cruise control and autostart


it sound to me like the transponder loop around the ignition switchor "key in the box" needs to be repositioned or the key sense wire circuit

Oct 23, 2008 | Hyundai Motor 2002 Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...