1992 hyundai excel coil will not fire. everything from coil to the dis is ok. turn dis hear injectors click "jump coil with battery it fires. HELP!!

If you pull coil wire from center of distributor cap, hold it close to metal part of engine. Have helper crank it, do you see/hear a spark jump? If so, the problem is in distributor. Make sure the rotor turns when you crank it.
Are you missing anything else? Engine cranking, do you have fuel injector pulse? If your missing both spark and fuel injector pulse, I'd have to check for rpm signal, comes from crank sensor.
I can only help with testing. You have to do the testing.

Is the distributor shaft turning when the vehicle is cranked?

Bad coil pack cyl 1&3 work off same segment

hyundai elantra If you want to solve your problem, click on the link I attached

MAY HAVE FAULT IN ECU//CHECK FUSES/WIRES AT ECU

Easy enough to check it out, you should be able to hear the fuel pump kick on when the key is turned, if you can't hear it, it might be the problem, but just to make sure, Squirt a little gas in the throttle and see if it will fire, usually even when the fuel pump goes bad the fuel will get into the injectors enough to fire it. Check it out.

I believe i would check my module or rotor it may not be getting enough fire.to the moter.

check your coil and see if you have fire.if you have fire then you need to check your fuel pressure. i have a mazda 2600i that did the same thing and it was the coil .did your truck back fire when you shout it off?. if it did iam pretty sure its your coil.note there is a module in side the dis very few people know about this but they are not notted for going bad good luck

have you checked the fuel pump?

http://www.autozone.com/N,26200242/shopping/specsSelect.htm

You can try the firing order if that doesnt work let me know ill keep helping