Check this reference guide...
2002 Hyundai Accent Car Lightbulb Size Guide
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 2357A
Front Turn Signal Light Bulb Size: 2357A
Rear Turn Signal Light Bulb Size: 1156
Tail Light Bulb Size: 1157
Stop Light Bulb Size: 1157
High Mount Stop Light Bulb Size: 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 1156
Front Side Marker Light Bulb Size: 2357A
Rear Sidemarker Light Bulb Size: 168
Map Light Bulb Size: DE3175
Dome Light Bulb Size: DE3175
Step/Courtesy Light Bulb Size: DE3022
Trunk/Cargo Area Light Bulb Size: DE3022
From Sylvania Lamp Replacement Guide
License plate
168
168LL Long Life Upgrade: Up to twice the life of the standard lamp.
I hope help you with this. Good luck (remember rated this help).
SOURCE: how do you change the license plate light bulb
OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....
SOURCE: '04 honda crv bulb change
Its a 5 Watt light bulb. Just pull it out and take it to the store with you. Just remove the license plate to get to it.
SOURCE: 1999 Dodge Neon rear license Plate bulb
LICENSE PLATE LAMP BULB
REMOVAL
INSTALLATION
SOURCE: License plate bulb replacement
First off, you have to remove the truck lid liner to a point where you can access the light plug from inside (The light cover will not come out without taking the socket and bulb out first). Twist the light plug and pull out. Then on the exterior of the light, take a small regular screwdriver and slide it in the slots on each side of the light cover assembly and push towards the center of the light. This will release the plastic clips and allow you to pull down on the light cover. Do this to each side, then pull down and out towards you to get the light cover off. Install in reverse.
1,848 views
Usually answered in minutes!
×