Where are my vaccum lines located at on my 2006 chevy colorado 2.8l

SOURCE: 2006 colorado

they seem to be under the aircleaner and intake components. The coil is at the back near the fire wall. take off the air duct work and go from there. be careful to reconnect all sensor hoses , wire plugs exactly the same way you took them off. I think you will need several tools before you get to the plugs.

Greg Bernett

• 2993 Answers
• Posted on Sep 03, 2009

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
2. Remove the left front wheel and wheelhouse liner.

1. Disconnect the knock sensor (KS) connector.
2. Detach the knock sensor (KS) from the engine block.

1. Attach the knock sensor (KS) to the engine block.
   • Tighten the bolt to 18 ft lbs (25 Nm).
2. Connect the knock sensor (KS) connector.
3. Install the left front wheelhouse liner and wheel.
4. Fully lower the vehicle.

SOURCE: 2006 colorado intermittently fails to start. It

Clean all the electrical connections you can get to under the hood with automotive electronics cleaner,dry with compressed air and pack each connector with di-electric grease.

Colin Stickland

• 22516 Answers
• Posted on Dec 27, 2009

SOURCE: I need to replace the blower resistor on my 2006

around the blower motor ,its all in one

SOURCE: gas filter location

On the 06+ Chevrolet Colorado models, the fuel filter is inside the gas tank and is supposed to be maintenance free.