I went to use my wipers on my jeep and they wont turn on now i replaced the fuse but nothing

One fuse. Motor is probably bad.

HI, turn off everything ,make sure wiper switch is in off position, unplug the wire connector to the wiper motor(install new fuse) turn key on, turn wiper switch on to first position then proceed till you have went thru all settings , then turn key off , turn switch off , check fuse/ blown fuse>>replace switch/ good fuse/ plug wire connector to wiper motor , turn key on turn wiper switch on to first position then proceed till you have went thru all settings ,wiper motor not wiping>>check fuse/blown fuse>> replace wiper motor/good fuse/ wiper motor not working>>> get a exorcist performed on it !!! <:0}

get an auto electrician to check the wiring

Have you checked the wiper motor for power and ground from the wiper switch? Possible wiper switch

Check the fuses,and then look at the fusible links,most likely on the starter,if they are good,replace the ignition switch.

On a 1986 jeep I believe it has a "wiper-turn-signal assembly" that is all part of the turn signal lever. (I think its a GM/Chevy style.) The new models have an assembly that's in the steering column behind the steering wheel. If I'm correct that its all part of the lever, that is almost definitely the problem - 98-99%. Pretty much the same answer for the newer versions also. I have replaced over a couple hundred in my "career". Keep smiling.

first check fuses if all good remove back hatch panel find wiper motor remove plug . turn the ignition key to on position turn on rear wiper now test wiper plug for power if no power replace wiper motor

just check all the fuses, could possably be the stork switch.

if you havent checked wiper fuse do that first if it is ok then your wiper motor probley went out it shounldn't be to had to replace

Hello and welcome to FixYa . Locate the dial that controls the brightness of the dashboardlights. If the control is not immediately evident. Make sure the brightness control is turned on. If it is and the lights aren't working, the problem may be a bad fuse. Check the fuse that controls the dashboard lights Replace the fuse if necessary. If just one part of the instrument panel is not lighting up, then you have either a burned-out bulb or a wiring problem.

Passenger side kick panel fuse breakdown for a 1996 jeep Cherokee Country

01 - 25A Rear Wiper/Washer
02 - 15A Radio, Cigar Lighter
03 - Empty
04 - 15A Passing Light
05 - 30A Blower Motor
06 - 30A (Circuit Breaker) Power Windows
07 - 02A ABS
08 - 20A Turn Signal Flasher
09 - 10A Radio/Clock Memory, Courtesy Lights, Glove Box, Cargo, Dome Lights, Telltales
10 - Empty
11 - 25A Headlamp Delay Module, Horn
12 - Empty
13 - 20A Power Door Locks
14 - Empty
15 - 15A Instrument Panel Lamps, Clock/Radio and Memory, Headlamp Switch, Parking Lamps
16 - 30A (Circuit Breaker) Power Seats, Trailer Tow
17 - 7.5A Instrument Cluster Gauges, Headlamp Delay Module, Chime Module, Overhead Console
18 - 25A Rear Defrost
19 - 05A Instrument Panel Lamps, Radio Illumination
20 - 5.5A (Circuit Breaker) Windshield Wipers and Washers

This should get you going. And you can always Ask Me.