SOURCE: Location of the oilpan and filter of my 1999 Chrysler 300M
there is a large plastic cover/shield under the car, remove it and the filter and oil pan are right there, the filter is in the front.
SOURCE: need location of coolant sensor on 2002 chrysler 300m
near the thermostat I think, look for this part.
SOURCE: programming instructions for a 1999 Chrysler 300M remote fob
Manual Programming Procedure (non scan tool)
1. Connect pin 1 of the 16-way data link connector to chassis ground or to pin 4 of
the 16-way data link connector.
2. Close all doors, turn ignition key to off.
3. Turn ignition key to Accessory.
4. Turn ignition to off, door locks will cycle once (in programming mode).
5. For each key FOB, press any button 3 times in a row to program code. When
programming is complete, the door locks will cycle once.
NOTE:
IF A SECOND KEY FOB REQUIRES PROGRAMMING, IT MUST BE PROGRAMMED WITHIN 1 MINUTE OF
PROGRAMMING
THE FIRST FOB PROGRAMMING. PRESS ANY BUTTON ON THE SECOND FOB 3 TIMES TO PROGRAM ITS CODE. WHEN PROGRAMMING IS COMPLETE, THE DOOR LOCKS WILL CYCLE ONCE.
6. The programming mode finishes after the following:
a. Programming of two key FOBS is completed.
b. One minute has passed since programming.
c. Pin 1 of 16-way data link connector is removed from ground connection.
d. Ignition switch is turned on.
e. Any of the doors are opened.
SOURCE: need to find starter on 2000 chrysler 300m
The starter is under the car on the left side by the oil filter. You will need to take off the oil filter, the motor mounts, and then take the starter off, their are 3-4 bolts holding the starter on, the hardest one to get off is the one on the top . You will need a swivel to get the top one off. It will take about 3 hrs or so as long as they give you a good starter at the store.
SOURCE: need to replace a idle air control valve on a 1999 300M Chrysler
Removal & Installation
To install:
To install:
55 views
Usually answered in minutes!
×